Cable Leader Cat6a 1ft 24AWG Red Network Ethernet Cable
- Network Ethernet Ca…
- 6A
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Cable Leader
A 1 ft Cat6a patch cable supporting 10 Gbps at 500 MHz over 100 m with 24 AWG bare copper, gold-plated RJ45 connectors and a snagless boot
This 1-foot orange Cat6a cable provides a short, tidy link between a PS5, Xbox, gaming PC or router and a nearby switch or wall jack. The 10GBASE-T rating at 500MHz means it handles 10 Gigabit traffic without the latency, jitter or packet loss typical of Wi-Fi. Stranded 24AWG bare copper conductors and a cross-spline core keep the signal clean across the four twisted pairs. Snagless moulded boots protect the locking clips during frequent reconnects.
Rated for 10GBASE-T across the full 100 metre Cat6a channel, the cable has ample bandwidth for multi-gigabit internet plans, NAS transfers and 4K streaming. It is fully backward compatible with Cat6 and Cat5e gear, so it drops into existing runs without replacing switches or patch panels. The 1ft length is intended for patch-panel-to-switch or console-to-router hops; longer runs need a longer cable. Maximum throughput depends on the connected ports and cabling standard, not on this patch cord alone.
As a passive copper cable it adds no heat, fan noise or electrical load to the rack or desk. The 6.9mm outer diameter and flexible PVC jacket route cleanly through tight cable-management channels without kinking. Gold-plated 50-micron contacts resist oxidation for reliable mating cycles, and the snagless boot prevents clip breakage during moves. RoHS compliant and UL & ETL verified for safety in home and office environments.
| Brand | GENERIC |
|---|---|
| Type | Network Ethernet Cables |
| Cat | 6A |
| Connector A | RJ45 |
| Connector B | RJ45 |
| Length | 1 ft. |
| Color | Orange |
| Shielded | No |
| Wire Gauge | 24 AWG |
Other versions of this model
Same family, different memory, cooler or clock — compare before you commit.
Yes — it is fully backward compatible with Cat6 and Cat5e, so the 500MHz Cat6a cable drops straight into your current panel and 10GBASE-T switch without any equipment changes.
Check the port LEDs on your switch or router — they should show a 10 Gbps connection — and run a speed test or iperf3 between two 10GBASE-T devices to verify throughput near 10 Gbps.
The cable ships with 8P8C RJ45 connectors on both ends, each fitted with 50-micron gold-plated contacts and snagless molded boots — no extra plugs or tools are required.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Also in this aisle
Same shelf, same checkout — eight coins and a 30-minute rate lock.
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
Pick the language the site speaks to you in.
No language matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?