We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Wilton 803 C-clamp, grey powder-coated forged steel frame, black oxide spindle, sliding T-handle

Wilton

Wilton 803 C-Clamp 3 in hand tool

SKU CH-YX17-QPSAX MPN 803

A regular-duty C-clamp with a 3 in jaw opening and 1-15/16 in throat depth for general clamping tasks

  • TypeClamps
  • FinishPowder Coat
  • 3 in jaw opening handles a wide range of workpieces
  • 1-15/16 in throat depth reaches past edges and flanges
  • forged steel body resists bending under heavy loads
  • powder coat finish protects against rust and wear
  • sliding T-handle gives strong leverage for tight clamping

3-inch C-Clamp with Swivel Pad

The Wilton 803 is a regular-duty C-clamp built from forged steel with a powder-coated finish. Its V-grooved anvil and included swivel pad adapt to flat, round or angled workpieces. A sliding T-handle provides leverage for tightening the black-oxide spindle. The clamp is new and ready for workshop use.

Suited for woodworking.

This clamp serves hobbyists and professionals who need up to three inches of jaw opening and nearly two inches of throat depth. It is not intended for users who require a wider opening, deeper reach or higher clamping force than the rated 3,000 lb. Buyers needing multiple clamps for simultaneous glue-ups should plan accordingly.

3,000 lb clamping force rating

The single figure that determines fit is the maximum clamping force of 3,000 lb. Verify that your application stays within this limit before purchase. The forged-steel frame and standard-thread spindle deliver consistent pressure up to that value.

Highlights

  • 3 in jaw opening handles a wide range of workpieces
  • 1-15/16 in throat depth reaches past edges and flanges
  • forged steel body resists bending under heavy loads
  • powder coat finish protects against rust and wear
  • sliding T-handle gives strong leverage for tight clamping

Specifications

BrandWilton
Model803
TypeClamps
FinishPowder Coat

Questions about this item

How can I confirm the 803 clamp is holding with the full 3,000 lb force after tightening the sliding T-handle?

Tighten the spindle until the forged steel body resists further turning; the black-oxide spindle and V-grooved jaw pad will then maintain the rated clamping force without slipping.

What comes with the Wilton 803 and what must I supply separately?

The clamp includes the forged steel frame, powder-coated finish, black-oxide spindle, sliding T-handle, and one V-grooved swivel pad; no extra accessories or fasteners are required for basic operation.

Which capacity of this regular-duty C-clamp should I choose for a 3 in maximum opening?

The 803 model provides exactly 3 in of jaw opening and 1-15/16 in throat depth, so select this version when those dimensions match your workpiece requirements.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.