We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Long copper-coloured pry bar with tapered point end

Westward

Westward 23X836 Non-Sparking Pry Bar 60 In 19 lb

SKU CH-AQKN-3THFM MPN 23X836

A 60-inch non-sparking pry bar made from beryllium copper alloy for safe use in hazardous environments

  • TypeNail Pullers, Wrecking & Pry Bars
  • MaterialBeryllium Copper Alloy
  • Weight19
  • Non-sparking safety for hazardous environments with beryllium copper alloy construction
  • Non-magnetic properties prevent interference near sensitive equipment
  • 60 inch length provides extended reach and leverage for heavy prying tasks
  • Tapered point end design enables precise nail pulling and wrecking work
  • Meets FM7910 standard for non-sparking tool performance and reliability

Non-Sparking Pry Bar for Hazardous Areas

The Westward 23X836 is a 60 in pry bar made from beryllium copper alloy for non-sparking and nonmagnetic performance. It meets FM7910 standards and suits maintenance crews working in flammable or explosive environments where ferrous tools pose an ignition risk.

Thermals Noise and Power Draw

As a manual hand tool, this pry bar generates no heat, noise or electrical draw during use. The 19 lb weight provides the mass needed for leverage without operator fatigue from vibration or motor feedback. California Proposition 65 applies to the alloy composition.

Build Quality and Daily Use

The tapered point end and straight angle allow precise insertion into tight gaps for prying or nail pulling. Copper-coloured handle identifies the non-sparking material at a glance. Tether-ready attachment point is absent, so lanyard users must add their own retention method. Not for builders who need a striking face or hammer head on the opposite end.

Highlights

  • Non-sparking safety for hazardous environments with beryllium copper alloy construction
  • Non-magnetic properties prevent interference near sensitive equipment
  • 60 inch length provides extended reach and leverage for heavy prying tasks
  • Tapered point end design enables precise nail pulling and wrecking work
  • Meets FM7910 standard for non-sparking tool performance and reliability

Specifications

BrandWestward
Model23X836
TypeNail Pullers, Wrecking & Pry Bars
MaterialBeryllium Copper Alloy
Weight19

Questions about this item

How do I safely position the 60 in beryllium copper alloy bar when starting a pry?

Place the tapered point fully into the gap before applying force; the straight end angle and nonmagnetic material prevent slippage on ferrous surfaces.

What maintenance does the 19 lb non-sparking pry bar require over time?

Inspect the tapered point for deformation after heavy use; wipe the copper-coloured handle clean and store dry to preserve the beryllium copper alloy finish.

At what point does the FM7910-rated bar show its limit during continuous prying?

The 60 in length and 19 lb mass concentrate leverage at the tapered end; sustained loads beyond the alloy yield point will cause permanent bend rather than fracture.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.