We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Silver chisel soldering tip, 1 mm thick, 40 mm long

Weller

Weller T0054470199 Soldering Tip Chisel XT 1 mm 40 mm

SKU CH-KE84-G505A

A 1.6 mm wide chisel tip for Weller WP 120 and WXP 120 handpieces, 40 mm long and rated to 850 °F

  • TypeWelding Parts & Supplies
  • Chisel profile delivers precise heat transfer for accurate joints
  • 6 mm tip width handles fine-pitch components with control
  • 40 mm tip length reaches confined board areas easily
  • XT series compatibility fits WP 120 and WXP 120 handpieces
  • Operates up to 850 Degrees F for demanding soldering tasks

Chisel tip for Weller XT series

This Weller XT chisel tip is a direct replacement for compatible Weller soldering stations and handpieces. It fits the WP 120 and WXP 120 handpieces used with WT1010H, WX1010, WX2020 and WXR3002 series stations. The tip is designed for general-purpose soldering tasks where a chisel profile is preferred.

Operates at 850 Degrees F maximum

The tip reaches a maximum operating temperature of 850 Degrees F during normal use. Its 1 mm thickness and 1.6 mm width concentrate heat efficiently at the joint. No cooling fan or active thermal management is required as the station regulates power delivery to the tip.

No bundled accessories or software

This item is supplied as a single soldering tip without additional nozzles, cleaning sponges or configuration software. Compatibility is limited to the Weller handpiece and station models listed above. Buyers needing different tip geometries or diameters must purchase separate XT-series tips.

Highlights

  • Chisel profile delivers precise heat transfer for accurate joints
  • 6 mm tip width handles fine-pitch components with control
  • 40 mm tip length reaches confined board areas easily
  • XT series compatibility fits WP 120 and WXP 120 handpieces
  • Operates up to 850 Degrees F for demanding soldering tasks

Specifications

BrandWELLER
TypeWelding Parts & Supplies

Questions about this item

How do I install the XT chisel tip on the WP 120 handpiece and what step causes poor contact?

Insert the tip fully until it seats on the 6 mm barrel; the step users skip is tightening the retaining nut while the tip is cold, which leaves a gap that breaks thermal transfer.

When will the 1 mm thick chisel face need replacement under daily soldering?

The iron-plated working surface wears gradually; expect to replace the tip when the 1.6 mm chisel edge becomes rounded or pitted, typically after several hundred joint cycles.

What is the first limit reached during a long session at 850 Degrees F on a WX1010 station?

Tip oxidation accelerates at the maximum 850 Degrees F rating, so the flux activity drops off before the station thermal limit, requiring more frequent cleaning or a brief pause.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.