We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Cylindrical metal standoff guide with threaded base and flared tip

Victor Thermal Dynamics

Victor Thermal Dynamics 7-5200 Standoff Cut Guide for SL100/SL60 Plasma Torches

SKU CH-9GRD-E23GR MPN 7-5200

Standoff cutting guide attaches to the shield cup for drag cutting with SL100 and SL60 plasma torches up to 100 A

  • TypeWelding Parts & Supplies
  • Precise standoff cuts with drag-cutting guide design
  • Fits SL100 and SL60 plasma torch series
  • Attaches directly to shield cup for stability
  • Compatible with multiple Thermal Dynamics torch models
  • Rated for plasma cutting up to 100 A

Standoff Cut Guide for SL100/SL60 Torches

This Victor Thermal Dynamics standoff cutting guide attaches directly to the shield cup of compatible plasma torches. It is designed for drag cutting at up to 100 amps. The guide fits a wide range of SL100 and SL60 series torch models. It provides a fixed standoff distance for consistent cut quality.

For Plasma Cutting Operators Using Compatible

Welders using Thermal Dynamics SL100 or SL60 torches listed in the compatibility data will find this guide fits their shield cup. It suits operators who perform drag cutting and need a repeatable standoff. Buyers with torches outside the specified model range or those requiring a different cutting configuration should look at other accessories.

Critical Spec Is the 100 Amp Maximum Current Rating

The guide is rated for a maximum current of 100 A. This single limit decides whether the part matches the amperage of your cutting application. Exceeding this rating risks damage to the guide and poor cut results. Verify your torch output stays at or below this figure before fitting the accessory.

Highlights

  • Precise standoff cuts with drag-cutting guide design
  • Fits SL100 and SL60 plasma torch series
  • Attaches directly to shield cup for stability
  • Compatible with multiple Thermal Dynamics torch models
  • Rated for plasma cutting up to 100 A

Specifications

BrandTHERMAL DYNAMICS
TypeWelding Parts & Supplies

Questions about this item

Does the 7-5200 standoff guide generate any extra heat or noise during extended plasma cutting at 100 A?

The guide is a passive metal attachment that adds no electrical load, so it produces no additional heat or noise beyond the torch itself.

Which shield cup must I already have on my SL100 or SL60 torch for the 7-5200 to attach?

The guide clamps directly onto the existing shield cup of compatible SL100 and SL60 torches; no separate cup is required.

Will the 7-5200 fit the older 7-5201 and 7-5260 torch models I still use?

Yes, the guide is listed for torch models 7-5201, 7-5260 and the full SL100/SL60 series shown in the compatibility list.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.