We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Victor 0333-0353 cutting tip size 0 for propylene fuel, two-piece design

Victor Thermal Dynamics

Victor Thermal Dynamics 0333-0353 Cutting Tip 0 MTH-P Propylene

SKU CH-T5SD-6NFQM

A propylene cutting tip for machine torches, handling 12 to 65 scfh with a 0.06 in kerf and up to 28 in/min cut speed

  • TypeWelding Parts & Supplies
  • Designed for propylene fuel with heavy preheat flame
  • Cuts 1/2 to 3/4 in steel at up to 28 in/min
  • Fuel flow range 12 to 65 scfh for consistent performance
  • Two-piece tip design produces 0.06 in kerf width
  • Compatible with MT 1065 and MT 5 machine torches

Victor 0333-0353 Cutting Tip — Propylene Fuel

This Victor 0333-0353 cutting tip is designed for machine torch cutting using propylene fuel. It belongs to the 1-MTHP series with a size 0 two-piece design. The tip fits compatible Victor MT 1065 and MT 5 series torches for fabrication, repair and maintenance work.

Suited for propylene-based machine cutting 1/2

Operators cutting mild steel between 1/2 in and 3/4 in thick with a compatible Victor machine torch will find this tip matches the required fuel flow range of 12 to 65 scfh. It is not for hand torches, alternative fuel gases such as acetylene, or cutting thicknesses outside the stated minimum and maximum range.

Two-piece tip installs on MT 1065 or MT 5 torches

The two-piece design seats onto Victor MT 1065N or MT 5 machine torches without special tools. A common issue is mismatching the tip series or fuel type, which leads to poor preheat and an irregular kerf width of approximately 0.06 in at speeds up to 28 in/min.

Highlights

  • Designed for propylene fuel with heavy preheat flame
  • Cuts 1/2 to 3/4 in steel at up to 28 in/min
  • Fuel flow range 12 to 65 scfh for consistent performance
  • Two-piece tip design produces 0.06 in kerf width
  • Compatible with MT 1065 and MT 5 machine torches

Specifications

BrandVICTOR
TypeWelding Parts & Supplies

Questions about this item

Which cutting torch series must I already own to use this tip?

The tip fits Victor MT 1065 and MT 5 series machine torches.

Can I keep using my existing propylene regulator and hose with this tip?

Yes — the tip operates at 12 to 65 scfh propylene flow, matching standard propylene supply setups.

How do I confirm the tip is performing correctly after installation?

Expect a heavy-preheat flame cutting 1/2 to 3/4 in material at up to 28 in/min with a 0.06 in kerf.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.