Victor
Victor 6700-2473 Cutting Tip GPN-3 Propane Natural Gas Welding
A two-piece cutting tip for propane or natural gas torches, compatible with Victor HC, MT and ST series torches and CA attachments, suited for steel cutting between 2 in and 2 1/2 in
- TypeWelding Parts & Supplies
- Cuts steel 2 in to 2 1/2 in thick with tip size 3
- Works with propane or natural gas for flexible fuel choice
- Fits Victor HC 1100C, HC 1200C and MT series torches
- Compatible with CA 2460, CA 2461, CA 2462 cutting attachments
- Two-piece tip design for reliable handheld and machine cutting
Victor Cutting Tip for Propane and Natural Gas
The Firepower 6700-2473 is a GPN-3 cutting tip built for steel cutting with handheld or machine torches. It accepts propane or natural gas and fits Victor torch series such as the HC 1100C and MT 200.
Replaces worn GPN series tips on compatible torches
Swap this tip when the old one no longer holds a clean kerf on 2 in to 2 1/2 in steel. The two-piece design matches the original GPN-3 geometry so the change restores factory cut quality without re-tuning the torch.
Fits Victor CA 2460 and CA 2461 series attachments
Mounts directly on cutting attachments including the CA 2460, CA 2461 and CA 411-1. No adapter is needed, freeing the operator to move between handheld and machine cutting on the same fuel setup.
Highlights
- Cuts steel 2 in to 2 1/2 in thick with tip size 3
- Works with propane or natural gas for flexible fuel choice
- Fits Victor HC 1100C, HC 1200C and MT series torches
- Compatible with CA 2460, CA 2461, CA 2462 cutting attachments
- Two-piece tip design for reliable handheld and machine cutting
Specifications
| Type | Welding Parts & Supplies |
|---|---|
| Brand | FIREPOWER |
Questions about this item
What torch series and cutting attachment models accept the GPN-3 tip?
The tip fits Victor torch series HC 1100C, HC 1200C, MT 1065, MT 200, MT 300, MT 5, ST 1000FC, ST 2600FC, ST 300FC, ST 400C, ST 900FC and cutting attachments CA 2460, CA 2460+, CA 2461, CA 2461+, CA 2462, CA 2462+, CA 411-1.
How do I correctly install the two-piece GPN-3 tip onto a compatible torch?
Screw the inner cutting tip into the outer preheat shell by hand, then tighten with a tip wrench until snug; the step often missed is verifying the O-ring seats evenly before final torque to prevent gas leaks.
When should the GPN-3 tip be replaced during regular steel cutting?
Replace the tip when the preheat flames become uneven, the cutting oxygen stream shows feathering, or the tip face exhibits pitting or erosion that widens the kerf beyond 2 1/2 in capacity.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
SIEMENS
SIEMENS 52PP2D2AB 30 mm Illuminated Push Button Red 24 V LED 1NO/1NC
$179.99
0.00215826BTC
In stock