We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Small boxy pressure switch with steel brass plastic housing rated 25 bar

Value Brand

Value Brand Pressure Switch 22-0243 HHB 25 bar

SKU CH-XH4Y-5JS3W

Pressure switch for Mi-T-M HHB compressors, rated to 25 bar and built from steel, brass and plastic

  • Compatible with Mi-T-M HHB series compressors for precise fit
  • Monitors and controls air pressure up to 25 bar maximum
  • Durable steel brass and plastic construction resists wear
  • Direct replacement pressure switch for reliable system operation
  • Genuine MI-T-M component ensures exact specifications match

MI-T-M 22-0243 HHB Pressure Switch

The MI-T-M 22-0243 is a pressure switch designed specifically for Mi-T-M Series HHB equipment. It monitors pneumatic pressure and triggers an electrical or mechanical response at the set point. Construction uses steel, brass and plastic materials for durability. This new component is rated for systems operating up to 25 bar maximum pressure.

Suits HHB series maintenance only

This switch fits owners servicing Mi-T-M HHB compressors where the original part number matches. It is not for operators running equipment from other manufacturers or different Mi-T-M series. Buyers needing alternate pressure ranges or thread configurations must verify specifications before ordering.

25 bar maximum operating pressure

The decisive specification is the 25 bar pressure rating which must match the system design limit exactly. Exceeding this rating risks component failure and safety hazards. Confirm the compressor nameplate shows the same maximum pressure before installing this switch.

Highlights

  • Compatible with Mi-T-M HHB series compressors for precise fit
  • Monitors and controls air pressure up to 25 bar maximum
  • Durable steel brass and plastic construction resists wear
  • Direct replacement pressure switch for reliable system operation
  • Genuine MI-T-M component ensures exact specifications match

Specifications

BrandMI-T-M

Questions about this item

Does this switch connect directly to the Mi-T-M Series HHB compressor unloader valve?

The switch is built for Mi-T-M Series HHB units and uses steel, brass and plastic fittings that match the original equipment ports.

Will the 25 bar rating protect my older Mi-T-M pump that was set lower?

The switch handles up to 25 bar, so it will operate safely at any lower cut-out pressure your existing pump requires.

How can I verify the 22-0243 is cycling at the correct pressure after fitting?

Watch the tank gauge while the compressor runs; the motor should stop and the unloader hiss when the needle reaches the factory cut-out setting.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.