Value Brand
Value Brand 24M022 Raised Panel Light Green 12 V DC 6mm
Green LED panel indicator mounts in a 6 mm hole, runs on 12 V DC at 20 mA, and is rated for 100 000 hours at IP40
- Engine BrandZORO SELECT
- Engine Size6mm Mounting dia
- Raised panel design eases installation in 6mm cutouts
- Green LED provides clear status indication at 12V DC
- Low 20mA draw reduces power consumption
- IP40 rating protects against solid particles
- 100000 hour average life extends service intervals
Raised Panel LED Indicator
This raised-panel indicator mounts in a six-millimetre hole and runs on twelve-volt direct current. A green LED provides clear status illumination for industrial control panels and automotive dashboards. Brass-plated chrome housing and ABS plastic body resist vibration in mobile equipment. The unit draws twenty milliamps and carries an IP40 rating for dust protection.
Upgrade from incandescent pilot lights
Replaces filament lamps that burn out after a few thousand hours with a solid-state LED rated for one hundred thousand hours average life. The jump is worth it when maintenance access is difficult or when panel vibration shortens bulb life. Solder-lead connections suit permanent wiring harnesses rather than quick-disconnect terminals.
Limits of twelve-volt DC and IP40
Operation is fixed at twelve volts DC; no internal resistor allows higher supply voltages without external circuitry. IP40 blocks solid objects but offers no water ingress protection, so the indicator suits enclosed cabinets only. Panel thickness must not exceed one hundred sixty thousandths of an inch for secure mounting.
Highlights
- Raised panel design eases installation in 6mm cutouts
- Green LED provides clear status indication at 12V DC
- Low 20mA draw reduces power consumption
- IP40 rating protects against solid particles
- 100000 hour average life extends service intervals
Specifications
| Engine Brand | ZORO SELECT |
|---|---|
| Engine Size | 6mm Mounting dia |
Questions about this item
What panel thickness and hole size does the 6 mm mounting diameter light require?
The light fits panels up to 0.160 in thick and mounts in a 6 mm diameter hole.
How is the 12 V DC LED wired, and what mistake should be avoided?
Leads are for soldering; apply 12 V DC with correct polarity and avoid overheating the ABS body during soldering.
When should the green LED be replaced given its rated life?
Rated at 100,000 hours average life; plan replacement when brightness drops noticeably after extended use.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



