We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Three yellow sandblasted steel magnetic bit holder extensions 2.4 4 6 inch 1/4 hex

Unique-Bargains

Unique-Bargains Magnetic Hex Bit Holder Extension 2.4/4/6-inch 1/4'' 3pcs

SKU CH-X36H-S18RG

Three magnetic bit-holder extensions in 60 mm, 100 mm and 150 mm lengths accept 1/4-inch hex shanks and are made from 45# steel with sandblasted finish

  • Three lengths extend reach for deep or awkward fasteners
  • 1/4-inch hex fits standard drill chucks and bits
  • Internal magnet grips bits firmly during use
  • 45# carbon steel with sandblast finish resists wear
  • Set includes 2.4, 4 and 6-inch extensions

Three lengths for drill-bit reach

This set supplies three magnetic bit-holder extensions measuring 60 mm, 100 mm and 150 mm overall. Each piece accepts a standard 1/4-inch hex shank on both the tool side and the bit side. The 45# carbon steel shafts are sandblasted for corrosion resistance.

Magnetic retention during continuous driving

An internal magnet seated inside the chrome tube holds insert bits firmly while the tool runs at speed. The 15 mm maximum diameter keeps the profile slim for access in tight cavities. Sandblasted steel resists wear when the extension transmits torque over long periods.

Simple chuck-and-go fitting

The 6.35 mm hex shank drops directly into any 1/4-inch quick-change chuck or impact driver without adapters. No locking collar or set screw is required; the magnetic interface alone secures the bit. Users who need a non-magnetic release or a longer reach than 150 mm will need a different solution.

Highlights

  • Three lengths extend reach for deep or awkward fasteners
  • 1/4-inch hex fits standard drill chucks and bits
  • Internal magnet grips bits firmly during use
  • 45# carbon steel with sandblast finish resists wear
  • Set includes 2.4, 4 and 6-inch extensions

Specifications

BrandUnique Bargains

Questions about this item

Does the 45# steel holder get hot or vibrate when used continuously in a drill?

The 45# steel construction with sandblasting resists heat build-up and vibration during extended drilling or driving tasks.

Will these extensions fit my existing 1/4-inch hex shank bits and drill chuck?

Yes, both the connection shank and the bit receiver are 6.35 mm (1/4-inch) hex, matching standard drill chucks and universal hex bits.

Can I use the 150 mm extension with an older cordless drill that has a worn chuck?

The 150 mm length and 15 mm diameter fit a standard 1/4-inch hex chuck; magnetic retention helps secure bits even if the chuck grip has loosened.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.