Unique-Bargains
Unique-Bargains KSD301 200°C 10A NC 6.3mm Pin 5pcs electrical timer switch
Five normally-closed thermal switches rated 10 A at 250 V, opening at 200 °C with 6.3 mm pins and 50 000-cycle life
- Opens at 200 °C for reliable over-temperature protection
- Normally closed contact stays powered until the set point is reached
- Rated 10 A at 110 V, 120 V or 250 V for broad appliance compatibility
- 3 mm pins fit standard 0.25 inch terminals for easy installation
- Tested to 50 000 cycles and 2 000 V AC with no arc phenomenon
Thermal cut-out for heating elements
A pack of five KSD301 switches rated at 200 °C and 10 A provides over-temperature protection for appliances such as water heaters, coffee makers and dryers. Each unit uses a normally-closed bimetal contact that opens when the sensing temperature is reached. The 6.3 mm quick-connect pins suit standard spade terminals. The switches are supplied new and ready for installation.
Passive operation with no standby draw
The bimetal mechanism needs no external power, so it adds zero idle consumption to the circuit. Contacts are rated for more than 50,000 cycles and withstand a 2,000 V AC dielectric test with no arc breakdown. Rated voltages cover 110 V, 120 V and 250 V supplies. Automatic reset restores the circuit once the temperature falls below the trip point.
Direct replacement for OEM safety stats
The 6.3 mm pin spacing matches many factory-fitted thermostats in heating appliances, allowing a like-for-like swap without rewiring. Five pieces cover multiple units or provide spares for maintenance stock. Buyers who need adjustable trip temperatures or a normally-open action type will require a different switch design.
Highlights
- Opens at 200 °C for reliable over-temperature protection
- Normally closed contact stays powered until the set point is reached
- Rated 10 A at 110 V, 120 V or 250 V for broad appliance compatibility
- 3 mm pins fit standard 0.25 inch terminals for easy installation
- Tested to 50 000 cycles and 2 000 V AC with no arc phenomenon
Specifications
| Brand | Unique Bargains |
|---|
Questions about this item
How do I wire the 6.3 mm pins on the KSD301 switch?
Slip 6.3 mm female spade terminals onto each pin; the switch is normally closed so the circuit runs through it until 200 °C opens the contacts.
When will the contacts wear out on these thermostats?
Rated for more than 50,000 action cycles; replace the unit once the contact life is approached.
What voltage limit appears first during continuous 200 °C operation?
The dielectric strength is tested at 2000 V AC for one minute; sustained voltages above that level will break down the insulation.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



