We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Black plastic battery holder with spring clip and dual wires, pack of seven

Unique-Bargains

Unique-Bargains Battery Case Holder 12V 23A N 7Pcs

SKU CH-WQAR-RSX15

Holds one 12V 23A N cell with spring clip and 4.7 inch leads, seven pieces

  • Spring clip design lets you insert batteries quickly
  • Dual-wire connector provides a ready-to-use power lead
  • Compact 35 x 13 x 12 mm body fits tight spaces
  • 12 cm cable gives flexible placement options
  • Pack of seven holders covers multiple devices

Battery case holder for 12V 23A cells

This pack contains seven black plastic holders sized for a single 12V 23A N battery each. Spring clips secure the cell while dual wires provide a ready-made connection point. The compact body measures 35 x 13 x 12 mm with a 12 cm lead. Hobbyists and repair technicians can integrate these into custom power packs or test fixtures without soldering directly to the battery.

Thermals noise and power draw

Passive plastic and metal construction generates no heat and emits no audible noise during operation. The holder adds negligible resistance to the circuit so the battery delivers its rated voltage without measurable loss. No external power is required and the 20 g unit imposes minimal load on any mounting surface.

What the bundled accessories change

Seven identical holders are supplied so multiple cells can be wired in series or parallel for higher voltage or capacity. Pre-attached 12 cm cables eliminate the need to source connectors or crimp tools for quick prototyping. Buyers who need a different lead length or connector type will have to modify the wires themselves.

Highlights

  • Spring clip design lets you insert batteries quickly
  • Dual-wire connector provides a ready-to-use power lead
  • Compact 35 x 13 x 12 mm body fits tight spaces
  • 12 cm cable gives flexible placement options
  • Pack of seven holders covers multiple devices

Specifications

BrandUnique Bargains

Questions about this item

How do I install the spring clip holder and which polarity step do people get wrong?

Snap the 12 V 23 A N cell into the black plastic body so the spring clip touches the positive end and the wire lead connects to the negative end; reversing them is the common error.

What maintenance or replacement will the spring clip and wires need later?

The metal spring clip can lose tension after repeated swaps and the 12 cm wires may fatigue at the solder joints, so plan to replace the holder if contact becomes intermittent.

What limit shows up first when the holder is used continuously in a high-drain device?

The thin 12 cm leads and small spring clip raise resistance under sustained current, causing voltage drop and heat before the plastic body reaches its thermal limit.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.