We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Three new 9V battery clips with 15cm red and black tinned leads, T-type plastic shells, compact buckle size 24 x 12.3 x 7.5mm

Unique-Bargains

Unique-Bargains 9V Battery Clip T-Type 15cm 3pcs

SKU CH-52Q7-2J6BV

Pack of three 9V T-type clips with 15cm pre-stripped leads for quick battery connections

  • T-type buckle fits standard 9 V batteries securely
  • 15 cm pre-stripped and tinned leads simplify soldering
  • Colour-coded red and black wires prevent polarity mistakes
  • Compact 24 × 12.3 × 7.5 mm housing suits tight DIY spaces
  • Three clips per pack provide ready spares for quick repairs

9V Battery Clip T-Type 15cm

This pack contains three T-type battery clips designed for standard 9V batteries. Each clip features a hard plastic buckle measuring 24 x 12.3 x 7.5mm and 15cm of stripped, tinned wire leads. One red and one black lead simplify polarity identification for soldering or DIY connections.

Replacing worn or loose 9V connectors

Swap these in when existing clips become brittle, loose, or corroded after repeated battery changes. The T-type shell grips the battery terminals securely, restoring a reliable connection for low-current devices. The upgrade is worth it when intermittent power causes device resets or signal loss in prototypes.

Fits compact enclosures and breadboard wiring

The 15cm leads reach between a battery holder and a nearby PCB without excessive slack. Thin wires keep the profile small inside tight cases or project boxes. This clip frees up board space compared to bulky holder frames, but the supplier notes the wires suit only very small current loads and will heat up under heavier draw.

Highlights

  • T-type buckle fits standard 9 V batteries securely
  • 15 cm pre-stripped and tinned leads simplify soldering
  • Colour-coded red and black wires prevent polarity mistakes
  • Compact 24 × 12.3 × 7.5 mm housing suits tight DIY spaces
  • Three clips per pack provide ready spares for quick repairs

Specifications

BrandUnique Bargains

Questions about this item

What are the exact dimensions of the T-type buckle so I can check it fits my 9V battery compartment?

The T-type buckle measures 24 × 12.3 × 7.5 mm (0.94" × 0.48" × 0.3") L×W×H, matching standard 9V battery snap dimensions.

How should I solder the 15 cm leads without damaging the thin wires?

Use a fine-tip iron at low heat; the 15 cm red and black leads are pre-stripped and tinned, so apply solder quickly to avoid melting the plastic shell or overheating the thin conductors.

When should I replace these clips if I use them for a low-current DIY project?

Replace the clips immediately if the wires feel warm during use, the insulation discolours, or the T-type buckle cracks — the supplier notes the thin wires suit only very small current loads.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.