We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Five silver soldering iron tips, 43mm long, 4.3mm hole diameter

Unique-Bargains

Unique-Bargains 900M-T-3C Soldering Iron Tips 5pcs 43mm 4.3mm

SKU CH-H05C-1PWAJ MPN 900M-T-3C

Pack of five 43 mm silver-tone tips with 4.3 mm hole diameter for Hakko 936 irons

  • Long-lasting tips resist oxidation for extended use
  • 3 mm hole diameter fits Hakko 936 irons
  • 43 mm total length suits standard soldering stations
  • Five tips per pack provide ready replacements
  • Lightweight 27 g net weight eases handling

Replacement tips for Hakko 936

This pack contains five silver-tone soldering iron tips built to the 900M-T-3C specification. Each tip measures 43 mm in total length with a 4.3 mm hole inner diameter. The set weighs 27 g and is designed as a direct drop-in for Hakko 936 stations.

For hobbyists and repair technicians

Makers who need a low-cost supply of standard chisel tips for everyday joints will find this set practical. Users requiring specialised geometries such as fine conical, bevel or hoof profiles should look at something else.

4.3 mm shank diameter decides fit

The 4.3 mm hole inner diameter is the single dimension that determines whether the tip seats correctly in your iron. Verify this measurement against your station before ordering.

Highlights

  • Long-lasting tips resist oxidation for extended use
  • 3 mm hole diameter fits Hakko 936 irons
  • 43 mm total length suits standard soldering stations
  • Five tips per pack provide ready replacements
  • Lightweight 27 g net weight eases handling

Specifications

BrandUnique Bargains

Questions about this item

Will the 4.3 mm hole diameter fit my Hakko 936 iron?

Yes, the 4.3 mm inner diameter matches the Hakko 936 shank so the tip seats correctly.

How do I install the 900M-T-3C tip without damaging the heater?

Loosen the retaining nut, slide the tip fully onto the heater until it stops, then tighten the nut — do not force it past the 43 mm length.

When should I replace one of the five tips in the pack?

Replace a tip when the plating wears through, the 4.3 mm hole becomes loose on the heater, or oxidation prevents wetting.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.