We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Five black rubber cable boots, 50 mm long, 14 mm outer diameter, 11 mm inner hole

Unique-Bargains

Unique-Bargains 5 Pcs Rubber Strain Relief Cord Boot Protector Cable Sleeve 50mm

SKU CH-JPMD-ZT36V

Five black rubber boots protect charger and power-tool cables from bending, each 50 mm long with an 11 mm inner hole and 14 mm outer diameter

  • Protects cables from bending damage with rubber strain relief boots
  • Fits wires up to 11 mm inner diameter for charger and tool cords
  • 50 mm length covers stress points on power tool and aviation plug cables
  • 14 mm outer diameter adds durable insulation without bulk
  • Five-piece set weighs 21 g for lightweight cable management

Rubber Strain Relief Boot Pack

This pack contains five rubber cord boot protectors designed for cable strain relief. They suit electricians and technicians who need to protect wiring on power tools, aviation plugs or phone chargers. Each boot slides over the cable end to reduce bending stress at the connection point.

Simple Slide-On Installation

Installation requires pushing the cable through the 11mm inner hole and seating the boot over the connector or plug body. The flexible rubber stretches to fit, then grips the cable jacket without tools. A tight fit on thicker jackets can make initial seating difficult, so confirm the cable outer diameter before starting.

Check Cable Diameter First

Verify that your cable outer diameter is smaller than the 11mm inner hole so the boot can slide on. The boot outside diameter is 14mm and overall length is 50mm, so ensure the connector body can pass through the hole and that the installed boot clears adjacent components. These are single-use fit items once seated.

Highlights

  • Protects cables from bending damage with rubber strain relief boots
  • Fits wires up to 11 mm inner diameter for charger and tool cords
  • 50 mm length covers stress points on power tool and aviation plug cables
  • 14 mm outer diameter adds durable insulation without bulk
  • Five-piece set weighs 21 g for lightweight cable management

Specifications

BrandUnique Bargains

Questions about this item

How do I confirm the cord boot is protecting the cable properly after fitting it?

After installation the cable should not bend sharply at the connector; the rubber sleeve keeps the wire straight where it meets the plug.

What comes in the package and what else is required?

Five black rubber cord boot protectors are included; no extra parts or tools are needed for fitting.

Which size should I choose for my cable?

Select this 50 mm long boot when your cable outer diameter is about 14 mm and the connector end is roughly 11 mm.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.