We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
M18 inductive sensor, plastic threaded barrel, M12 connector

Turck

Turck NI8-S18-AP6X-H1141 46526 Inductive Sensor PNP M18x1

SKU CH-WY2Y-Y4F25 MPN NI8-S18-AP6X-H1141

M18 inductive proximity sensor with 8 mm switching distance, PNP NO output, M12 connector and PA12-GF30 housing

  • TypeTest Equipment
  • Item Count1 pack
  • Selling UnitBox
  • Parts3 Years
  • Labor1 Year
  • 8 mm switching distance for reliable detection
  • PNP normally-open output suits standard PLC inputs
  • M12 connector enables quick cable changes
  • PA12-GF30 housing resists oils and impacts
  • Non-flush M18 thread mounts without a metal-free zone

Inductive Sensor PNP M18x1

The Turck NI8-S18-AP6X-H1141 is an 8 mm rated switching distance inductive sensor with a PNP normally open output. It suits automation engineers and electricians who need reliable metal detection in industrial control systems. The threaded M18 x 1 barrel allows straightforward mounting on machine frames or brackets. A PA12-GF30 plastic housing resists oils and coolants common in production environments.

Upgrade from flush-mount or NPN types

This non-flush sensor replaces flush-mount units when the application requires greater sensing range through a non-metallic gap. It also supersedes NPN output sensors where the controller input expects a PNP sourcing signal. The jump is worth it when the installation demands the longer 8 mm reach or when the PLC input card is PNP only.

Check voltage and connector before ordering

Verify that the supply voltage matches the DC 1030 VDC rating stated for the sensor. Confirm the controller uses a compatible M12 x 1 male connector for the electrical connection. Ensure the mounting location provides enough clearance for the non-flush threaded barrel design.

Highlights

  • 8 mm switching distance for reliable detection
  • PNP normally-open output suits standard PLC inputs
  • M12 connector enables quick cable changes
  • PA12-GF30 housing resists oils and impacts
  • Non-flush M18 thread mounts without a metal-free zone

Specifications

BrandTURCK
ModelNI8-S18-AP6X-H1141 46526
TypeTest Equipment
Item Count1 pack
Selling UnitBox
Parts3 Years
Labor1 Year

Questions about this item

What thread size and housing material does the M18×1 sensor use?

The sensor has an M18×1 threaded barrel made from PA12-GF30 plastic.

How do I wire the M12×1 connector for the PNP output?

Connect the three DC wires to the M12×1 male plug matching the PNP NO pinout; the common error is swapping the signal and ground pins.

When should I check or replace the non-flush inductive sensor?

Inspect the sensing face after any impact or heavy contamination; the three-year parts coverage applies if the switching distance drifts from the rated 8 mm.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.