We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
TechSpray 1672-10S Diagnostic Freezer 10 oz aerosol can

TechSpray

TechSpray 1672-10S Diagnostic Freezer 10 oz soldering

SKU CH-4CMJ-X790F

Freezes components to 10 oz for circuit diagnostics in a non-flammable, plastic-safe spray

  • TypeSolders & Supplies
  • Plastic-safe formula protects sensitive components during troubleshooting
  • 10 oz trigger spray delivers precise targeted cooling
  • Non-flammable solvent eliminates fire risk near live circuits
  • Zero VOC content meets strict environmental requirements
  • 1,1,1,2-Tetrafluoroethane base provides rapid thermal shock for fault isolation

Diagnostic Freezer for Electronics Repair

TechSpray 1672-10S is a 10 oz trigger-spray freezer formulated for circuit-board troubleshooting. The non-flammable, plastic-safe solvent targets intermittent faults by rapidly cooling components to reveal thermal failures. Technicians and hobbyists use it to isolate defective solder joints, sensors or ICs without damaging surrounding plastics. The chemical-based formula contains zero VOCs and leaves no residue.

Thermals Noise and Power Draw

As an aerosol consumable, the product draws no electrical power and produces no acoustic noise during application. The 1,1,1,2-Tetrafluoroethane propellant delivers a focused freeze blast that evaporates instantly at room temperature. Non-flammable chemistry eliminates ignition risk near live circuits. The trigger-spray canister allows controlled, single-handed operation for precise spot cooling.

Plastic-Safe Compatibility Decides Fit

The solvent is verified safe on all plastics, making it suitable for dense boards with mixed-material housings. Boards containing plastic connectors, insulators or enclosures can be sprayed directly without risk of crazing or melting. Buyers who need a dielectric-rated cleaner or a chlorinated formula for heavy flux removal cannot use this product. The 10 oz canister suits bench use but not high-volume production lines.

Highlights

  • Plastic-safe formula protects sensitive components during troubleshooting
  • 10 oz trigger spray delivers precise targeted cooling
  • Non-flammable solvent eliminates fire risk near live circuits
  • Zero VOC content meets strict environmental requirements
  • 1,1,1,2-Tetrafluoroethane base provides rapid thermal shock for fault isolation

Specifications

BrandTECHSPRAY
TypeSolders & Supplies

Questions about this item

How do I install the 1672-10S Diagnostic Freezer, and what step do people often miss?

Shake the 10 oz trigger spray can well, hold it upright, and spray directly onto the target area from a short distance; the step often missed is keeping the can vertical so the liquid propellant does not escape.

What maintenance or replacement will the 1672-10S need later?

The 10 oz can is a single-use consumable; when the 1,1,1,2-Tetrafluoroethane runs out, replace the entire can — no internal parts are serviceable.

What limit appears first when using the 1672-10S continuously?

The can empties after roughly 10 oz of spray, and rapid discharge causes the container to chill sharply, reducing pressure and spray force until it warms again.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.