Taco Inc
Taco Inc 0010-SF3-IFC Learning Thermostat
A potable-water circulator with stainless-steel housing, 115 V single-phase power and flange connections for ¾ to 1½ inch pipe
- TypeLearning Thermostats
- Stainless steel housing resists corrosion in potable water systems
- Direct drive design reduces mechanical wear and maintenance needs
- Learning thermostat adapts heating patterns for efficient comfort control
- 28 gpm maximum flow at 1 ft head meets high-demand circulation
- 14 gpm at 6 ft head delivers optimal efficiency for hydronic loops
Stainless-steel circulator for open-loop potable
The Taco 0010-SF3-IFC is a direct-drive circulator built for open-loop potable-water systems. Its stainless-steel housing handles flange connections from three-quarter inch up to one-and-a-half inch. The unit runs on single-phase 115 VAC power with a one-eighth horsepower motor.
Steady-flow performance at operating head
At the best-efficiency point the pump moves 14 gallons per minute against six feet of head. The shut-off head reaches nine feet, while the minimum rated flow delivers eight gallons per minute at eight feet of head. These figures describe sustained operation rather than a brief peak.
Replaces older bronze or iron-body circulators
The stainless construction eliminates the corrosion risk found in traditional bronze or cast-iron bodies on potable-water loops. The jump is worth it when the existing circulator shows scaling, leaks or reduced flow after years of service. Builders needing a closed-loop design or a different voltage should look elsewhere.
Highlights
- Stainless steel housing resists corrosion in potable water systems
- Direct drive design reduces mechanical wear and maintenance needs
- Learning thermostat adapts heating patterns for efficient comfort control
- 28 gpm maximum flow at 1 ft head meets high-demand circulation
- 14 gpm at 6 ft head delivers optimal efficiency for hydronic loops
Specifications
| Brand | TACO |
|---|---|
| Type | Learning Thermostats |
Questions about this item
How much power does the 115VAC motor draw when the circulator runs continuously?
The pump uses a 1/8 HP motor rated for 115VAC single-phase supply.
Which pipe flanges must already be in place for the 3/4" to 1-1/2" connections?
Matching flanged pipe ends from 3/4 inch up to 1-1/2 inch are required for the face-to-face mounting.
Will the 6-3/8 inch face-to-face length fit the existing loop without re-piping?
The unit measures 6-3/8 inches between flange faces, so the current loop must match that spacing.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



