We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Eight brass pin punches in a row, each 4 inches long with size markings on the heads

Starrett

Starrett SB565Z Brass Drive Pin Punch Set 4 In 8 Pc

SKU CH-XNKT-MFKNE MPN SB565Z

Eight brass drive pin punches, four inches long, with sizes stamped on the head for quick identification

  • TypeHand Held Punches
  • Eight-piece brass set covers common pin sizes
  • Stamped head markings speed size identification
  • One-piece brass construction resists deformation
  • Four-inch length reaches confined work areas
  • Standard tether points improve tool security

Starrett Brass Drive Pin Punch Set

The Starrett SB565Z set supplies eight brass drive pin punches, each 4 in. long, for driving pins and aligning components without marring finished surfaces. Sizes are stamped on the head for quick selection, and the one-piece brass construction resists deformation during repeated use. Standard tethering capability lets you secure the tools when working at height or in confined areas.

Technicians needing non-marring pin removal

Maintenance technicians, gunsmiths and assembly workers who must protect soft metals, polymer frames or finished parts will appreciate the brass material. Workers who require hardened steel punches for driving into tough alloy steels or breaking frozen fasteners should choose a steel punch set instead.

Eight-piece brass set

The set covers 1/16 in. through 7/32 in. in eight increments, all in a uniform 4 in. length. Brass construction and stamped head markings are the defining specifications that determine whether this kit matches the application.

Highlights

  • Eight-piece brass set covers common pin sizes
  • Stamped head markings speed size identification
  • One-piece brass construction resists deformation
  • Four-inch length reaches confined work areas
  • Standard tether points improve tool security

Specifications

BrandStarrett
ModelSB565Z
TypeHand Held Punches

Questions about this item

What size drift punch or starter punch do I need to begin removing a pin before I switch to the 4 in brass pin punches?

Start the pin with a drift or starter punch slightly larger than the pin diameter, then drive it out using the matching 1/16, 3/32, 1/8, 5/32, 3/16, 7/32, 1/4 or 5/16 in brass punch from the set.

Will the brass tips on these 4 in pin punches mushroom when struck with the same steel hammer I use on my steel punches?

Brass is softer than steel, so the tips will mushroom faster; use a brass or dead-blow hammer, or accept more frequent re-dressing of the punch heads.

How do I confirm each 4 in brass punch is the size marked on its head before I start a job?

Measure the tip diameter with a caliper or micrometer and compare it to the stamped size — 1/16, 3/32, 1/8, 5/32, 3/16, 7/32, 1/4 or 5/16 in — to verify the correct punch is in hand.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.