We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Gray zinc wall-mounted control station with two mushroom push buttons, black and red, 30 mm size

SQUARE D

SQUARE D 9001BW250 Control Station Dead-End 2 Button Black Red

SKU CH-PT5T-A1WAR

Two-button 30 mm push-button station with momentary black start and red mushroom-head stop operators, 1NO/1NC contacts rated 5 A at 600 V AC, zinc enclosure rated NEMA 4 and IP66

  • TypeIndustrial Electrical Controls & Automation
  • Size30 mm
  • Two start/stop push buttons in one compact station
  • 30 mm operators fit standard industrial panels
  • Zinc enclosure rated NEMA 4 and IP66 for harsh environments
  • Contacts rated 5 A at 600 V AC and 24 V DC
  • Wall-mount design with 1/2 to 3/4 in NPT hub

Industrial two-button control station

The Square D 9001BW250 is a wall-mounted control station with two push-button operators in black and red. It carries a Start/Stop legend and provides one normally-open and one normally-closed contact rated at 5 amps. The zinc enclosure measures 30 mm and meets NEMA 4 and IP66 ratings for dust and water ingress protection.

Rated for harsh environments

The enclosure is constructed from zinc with a gray finish and carries both NEMA 4 and IP66 ratings. Contacts are designated B600/P600 for 600 V AC and 24 V DC operation. The momentary mushroom-head action is designed for reliable switching in industrial settings without a mechanical interlock.

Wall mount with conduit entry

The station mounts directly to a wall and accepts conduit hubs from 1/2 inch to 3/4 inch NPT. Overall dimensions are 3.6 inches high, 2.76 inches wide and 4.25 inches deep. The dead-end layout suits single-station installations where a compact, sealed operator interface is required.

Highlights

  • Two start/stop push buttons in one compact station
  • 30 mm operators fit standard industrial panels
  • Zinc enclosure rated NEMA 4 and IP66 for harsh environments
  • Contacts rated 5 A at 600 V AC and 24 V DC
  • Wall-mount design with 1/2 to 3/4 in NPT hub

Specifications

BrandSQUARE D
TypeIndustrial Electrical Controls & Automation
Size30 mm

Questions about this item

How do I wire the 1/2 in to 3/4 in NPT hub on the 9001BW250, and what step do people skip?

Thread conduit into the hub, tighten the locknut, then pull wires through; the step often missed is seating the gasket so the IP66 seal holds.

Which part of the 9001BW250 wears out first and needs replacement?

The push-button contacts rated 5A at 600V AC will wear after repeated momentary cycles; the zinc enclosure and mushroom heads typically outlast them.

What thermal or electrical limit appears first during continuous operation of the 9001BW250?

The 5A contact rating at 600V AC is the limiting factor; sustained loads above that will overheat the contacts before the IP66 enclosure reaches any temperature limit.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.