We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Black rubber and TPE propane hose, ten feet long, brass FLH fittings on both ends

SIEVERT

SIEVERT 1510IS liquid propane gas hose 10 ft 350 psi

SKU CH-28AN-DXM69

10 ft liquid propane hose rated 350 psi with brass FLH fittings to EN 559/ISO 3821

  • TypeWelding Parts & Supplies
  • 10 ft length reaches distant work areas
  • 350 psi rating handles high-pressure propane tasks
  • EN 559/ISO 3821 compliance meets recognised safety standards
  • Brass FLH fittings on both ends ensure secure leak-free connections
  • Rubber tube with TPE cover resists wear in tough environments

SIEVERT 1510IS liquid propane hose

The SIEVERT 1510IS is a coupled hose assembly built for liquid propane supply in welding and heating tasks. Its quarter-inch bore and ten-foot length suit workshop benches and portable torch kits where a flexible, fuel-rated line is required. The black rubber tube and TPE cover resist abrasion while staying pliable in cold conditions. Brass FLH fittings on both ends thread onto standard 9/16-inch connections without adapters.

Capacity and pressure headroom

Rated to 350 psi at 70 °F, the hose handles typical propane regulator outputs with a comfortable safety margin. The quarter-inch inside diameter delivers sufficient flow for single-torch brazing, soldering and light cutting jobs. Running multiple high-demand torches or feeding a large furnace will exceed the bore’s practical flow limit. The rubber tube is graded only for liquid propane; it must not be used with acetylene, natural gas or oxygen.

EN 559 and ISO 3821 compliance

The hose meets EN 559 and ISO 3821 standards for rubber and thermoplastic welding hoses, confirming its construction, marking and pressure testing for propane service. This certification is the primary indicator that the assembly is fit for regulated professional use. Buyers needing a hose approved for other fuel gases or higher working pressures should select a differently certified product.

Highlights

  • 10 ft length reaches distant work areas
  • 350 psi rating handles high-pressure propane tasks
  • EN 559/ISO 3821 compliance meets recognised safety standards
  • Brass FLH fittings on both ends ensure secure leak-free connections
  • Rubber tube with TPE cover resists wear in tough environments

Specifications

TypeWelding Parts & Supplies
BrandSIEVERT

Questions about this item

Will the 10 ft SIEVERT 1510IS hose connect to my existing 9/16 in FLH brass fittings?

Yes, both ends have 9/16 in FLH brass fittings that match the same interface on your current regulator or torch.

How can I confirm the hose is rated for 350 psi at 70 F after installation?

Check the printed markings for EN 559/ISO 3821 and the 350 psi rating, then pressure-test the assembly at the working pressure before lighting.

Does the box include a regulator or torch, or just the coupled hose assembly?

Only the 10 ft coupled hose assembly is supplied; regulator, torch and any thread-seal tape must be purchased separately.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.