We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Pintech PA1010 benchtop high-voltage DC supply with LED display and front-panel knob

Pintech

Pintech PA1010 High Voltage DC Power Supply 10kV 10W

SKU CH-KHAD-AMFW8

A 10 W bench-top DC supply delivering up to 10 kV with over-current, over-voltage and over-temperature protection

  • TypeDC Power Supplies
  • Voltage10kV
  • 10 kV output at 10 W for demanding lab tasks
  • Over-current, over-voltage and over-temperature protection guards users and equipment
  • Closed-loop control keeps voltage and current stable within 0.05 % over 8 hours
  • LED digital meter shows real-time voltage and current readings
  • Knob, external potentiometer, PLC or PC remote control via 0–10 V signal

High-Voltage Bench Supply for Lab Use

The Pintech PA1010 delivers a regulated 10kV DC output rated at 10W from a 110V AC input. It is intended for laboratory, test-bench and industrial applications that require a stable high-voltage source. Closed-loop control keeps voltage and current steady during extended runs. An LED digital meter shows real-time readings for both parameters.

Protection and Stability in Operation

Over-current, over-voltage and over-temperature safeguards protect the unit and connected equipment. Load regulation is 0.01% and line regulation is ±0.01%. Long-term drift stays below 0.05% over eight hours after a half-hour warm-up at 50/60Hz. The desktop enclosure relies on passive cooling suited to the 10W rating.

Remote Control and Output Connector

Output voltage can be set locally via the front-panel knob or remotely with a 0-10V control signal. Monitoring ports provide a 0-5V or 0-10V signal proportional to the actual output. The high-voltage lead uses an aerial plug connector type 16 with an effective cable length of 1m. Input accepts 110V ±10% at 50/60Hz.

Highlights

  • 10 kV output at 10 W for demanding lab tasks
  • Over-current, over-voltage and over-temperature protection guards users and equipment
  • Closed-loop control keeps voltage and current stable within 0.05 % over 8 hours
  • LED digital meter shows real-time voltage and current readings
  • Knob, external potentiometer, PLC or PC remote control via 0–10 V signal

Specifications

TypeDC Power Supplies
Voltage10kV

Questions about this item

How do I connect the aerial plug connector type 16 to my test setup and what is the one step people forget?

Plug the 1 m high-voltage output cable into the aerial plug connector type 16 on the front panel; the step most users miss is allowing the unit to warm up for half an hour before relying on the 0.05 % stability spec.

What maintenance will the PA1010 need over time?

No user-serviceable parts are listed; keep the ventilation slots clear, verify the over-temperature protection trips cleanly during periodic checks, and inspect the 1 m high-voltage cable for insulation damage.

What limit appears first when I run the supply at 10 kV continuously?

The 10 W power ceiling caps output current at 1 mA, so sustained full-voltage operation is limited by thermal protection long before the 0.01 % line-regulation figure becomes relevant.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.