We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Solid carbide router bit with spiral O-flute upcut design

Onsrud

Onsrud 63-530 carbide routing end mill hand tool

SKU CH-WE6G-H096W MPN 63-530

Carbide upcut O-flute router bit cuts acrylic cleanly with upward chip evacuation

  • TypeHole, Drill, Bore & Wire Gauges
  • MaterialCarbide
  • Carbide construction resists wear for extended tool life
  • Upcut O-flute geometry clears chips efficiently in acrylic
  • 1/4 inch cutter diameter suits precision routing tasks
  • Solid router bit design ensures rigidity during cutting
  • California Proposition 65 notice indicates regulated material content

Carbide up-cut O-flute router bit

This solid carbide router bit uses an up-cut O-flute spiral to evacuate chips cleanly while cutting acrylic and similar plastics. The 1/4 inch cutter diameter and 3/4 inch flute length suit detailed profiling and grooving tasks. It is built for CNC routing and hand-held use where a sharp, wear-resistant edge is required. The tool arrives new and ready for immediate workshop use.

For plastic fabrication and sign shops

The geometry is optimised for acrylic, so sign makers, display builders and plastics fabricators will get clean edges without melting. Woodworkers cutting hardwoods or abrasive composites should look elsewhere because the O-flute is not designed for those materials. Buyers who need a down-cut or compression spiral for double-sided laminates will not find that action here.

1/4 inch cutter diameter decides fit

The 1/4 inch shank and cutter diameter determine whether the bit fits your collet and matches the programmed tool path. If your machine or project calls for a different diameter, this bit cannot be substituted without changing the tooling setup. Check the required cutter size before ordering.

Highlights

  • Carbide construction resists wear for extended tool life
  • Upcut O-flute geometry clears chips efficiently in acrylic
  • 1/4 inch cutter diameter suits precision routing tasks
  • Solid router bit design ensures rigidity during cutting
  • California Proposition 65 notice indicates regulated material content

Specifications

BrandOnsrud
Model63-530
TypeHole, Drill, Bore & Wire Gauges
MaterialCarbide

Questions about this item

Does the carbide end mill produce noticeable heat or noise during continuous routing of acrylic?

The solid carbide 63-530 runs cool because the O-flute upcut clears chips efficiently, reducing friction and keeping both noise and heat low during long acrylic cuts.

What tool holder or collet size is required to run the 1/4 in cutter diameter shank?

A standard 1/4 in collet or ER collet matching the shank diameter is all that is needed to secure the bit in any CNC router or hand-held router.

Will the upcut spiral pull chips upward on an older CNC router that lacks through-spindle coolant?

Yes, the upcut O-flute design evacuates chips upward even without coolant, so the bit works reliably on legacy machines that only have external dust extraction.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.