We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Copper braided solder wick on spool, 2.5mm wide, 1.5m length

No-Clean Solder Braided Wick 2.5mm 1.5m Roll

SKU CH-RV1B-TJAMC

No-clean copper braid, 2.5 mm wide and 1.5 m long, absorbs excess solder without residue for PCB rework

  • Compatibility/Fitmentk675nn
  • Standards/Certificationstrue
  • No-clean flux leaves no residue on boards
  • Pure copper braid conducts heat quickly for fast absorption
  • 5 mm width fits narrow component spacing
  • 5 m roll supplies enough length for repeated jobs
  • Fine flat-stitch weave gives strong capillary action

Desoldering wick for PCB rework

This 2.5 mm wide, 1.5 m roll of no-clean copper braid is built for electronics technicians and hobbyists correcting solder joints on printed circuit boards. The fine flat-weave construction draws molten solder away through capillary action without leaving flux residue that requires cleaning.

Sustained desoldering performance

During continuous use the pure copper strands maintain rapid heat transfer so each fresh section of wick absorbs solder quickly. The braid does not saturate after a single joint; users simply trim the spent portion and continue working along the roll without waiting for the material to cool.

Practical limits of braided wick

The 2.5 mm width fits most through-hole pads and small surface-mount pads but cannot span wide power planes or large ground pours in a single pass. Very fine-pitch leads may need a narrower braid, and heavy multi-layer boards can demand more thermal mass than the thin copper ribbon supplies.

Highlights

  • No-clean flux leaves no residue on boards
  • Pure copper braid conducts heat quickly for fast absorption
  • 5 mm width fits narrow component spacing
  • 5 m roll supplies enough length for repeated jobs
  • Fine flat-stitch weave gives strong capillary action

Specifications

Compatibility/Fitmentk675nn
Standards/Certificationstrue

Questions about this item

Does the 2.5 mm braid generate noticeable heat during long desoldering sessions?

The pure copper braid conducts heat quickly from the iron tip into the solder, so the wick itself stays close to the iron temperature; no extra heat source is created.

What soldering iron tip size works with the 2.5 mm width?

A standard conical or chisel tip that covers the 2.5 mm braid is sufficient; the flat-stitch weave makes contact across the full width.

Will the no-clean flux residue interfere with older through-hole joints I plan to re-solder?

The no-clean formulation leaves a non-conductive residue that does not need removal, so existing through-hole pads can be re-soldered directly.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.