We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Small brass cutting tip with threaded base and precision orifice

Miller-Smith Equipment

Miller-Smith Equipment SC60-2 Cutting Tip SC

SKU CH-MN44-BCZ48

Cuts 3/4 to 1 1/4 inch steel using propylene fuel with SC60 series torches

  • TypeWelding Parts & Supplies
  • Designed for propylene fuel, optimised for handheld and machine torches
  • SC60 series two-piece tip handles 3/4 in to 1 1/4 in steel
  • Fits DG and SC torch series plus SC205 and SC209 attachments
  • Smith Equipment manufacture ensures consistent cut quality
  • California Proposition 65 warning: contains chemicals linked to cancer and reproductive harm

SC60-2 Cutting Tip for Propylene

The SC60-2 is a two-piece cutting tip designed for oxy-fuel cutting with propylene fuel gas. It fits handheld and machine torches that accept the SC60 series. The tip handles steel plate from 3/4 in up to 1 1/4 in thick. It is built for metal fabrication, maintenance and repair work.

Replaces worn SC60 series tips

Swap this tip in when an existing SC60-2 shows pitting, erosion or an irregular flame pattern that degrades cut quality. The change is worth it when the current tip no longer holds a clean kerf at the 3/4 in to 1 1/4 in range. It restores factory cutting performance for propylene-based operations.

Verify torch and attachment compatibility

Confirm your cutting torch belongs to the DG or SC series before ordering. The tip also requires a compatible SC205 or SC209 cutting attachment. Ensure your fuel supply is propylene; the tip is not rated for other fuel gases. Check local regulations regarding Proposition 65 warnings.

Highlights

  • Designed for propylene fuel, optimised for handheld and machine torches
  • SC60 series two-piece tip handles 3/4 in to 1 1/4 in steel
  • Fits DG and SC torch series plus SC205 and SC209 attachments
  • Smith Equipment manufacture ensures consistent cut quality
  • California Proposition 65 warning: contains chemicals linked to cancer and reproductive harm

Specifications

TypeWelding Parts & Supplies
BrandSMITH EQUIPMENT

Questions about this item

What torch series and attachment models does the SC60-2 tip fit?

The tip fits DG and SC torch series and SC205 and SC209 cutting attachments.

What fuel type and tip design are required for installation?

The tip uses propylene fuel and a two-piece design; the splines must align before tightening.

When should the tip be replaced based on cutting performance?

Replace the tip when cut edges become rough or the kerf widens beyond 1 1/4 inches.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.