We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Grey chisel soldering tip 0.5 mm wide

Master Appliance

Master Appliance 70-01-13 Soldering Tip Chisel 0.5 mm

SKU CH-E0Z7-MSRJY

Chisel soldering tip 0.5 mm wide for UT-100 series handpieces, rated to 932 °F

  • TypeBroaches
  • Chisel tip creates broad contact for efficient heat transfer
  • 5 mm width suits fine-detail soldering work
  • Withstands up to 932 °F for demanding applications
  • Fits UT-100 and UT-100Si series handpieces
  • Gray finish resists oxidation during use

0.5 mm chisel tip for UT-100 handpieces

This Master Appliance 70-01-13 soldering tip is a chisel type measuring 0.5 mm wide. It belongs to the UT-100Si series and is designed for use with compatible Master Appliance handpieces such as the UT-100, UT-100-TC and UT-100Si models. The tip is new and supplied in a grey finish.

Drop-in fit for listed handpieces

Installation is a simple matter of inserting the tip into any of the compatible handpieces listed in the specifications. No additional tools or calibration steps are required. The only common issue occurs when the tip is forced into a non-listed handpiece, which can damage the heater or prevent proper thermal contact.

Stable at 932 °F continuous rating

The tip is rated for a maximum operating temperature of 932 degrees Fahrenheit. It maintains consistent heat transfer during extended soldering sessions without the temperature drop-off seen in short-burst use. The chisel geometry distributes heat evenly across the 0.5 mm face for repeatable joint quality.

Highlights

  • Chisel tip creates broad contact for efficient heat transfer
  • 5 mm width suits fine-detail soldering work
  • Withstands up to 932 °F for demanding applications
  • Fits UT-100 and UT-100Si series handpieces
  • Gray finish resists oxidation during use

Specifications

BrandMASTER APPLIANCE
TypeBroaches

Questions about this item

How can I confirm the 0.5 mm chisel tip is heating correctly after installation?

The tip should reach the maximum operating temperature of 932 Degrees F and transfer heat evenly across the 0.5 mm chisel face when seated in a compatible UT-100 series handpiece.

What comes in the package and what must I supply to use this tip?

The package contains the 70-01-13 chisel tip only; a Master Appliance UT-100, UT-100-TC, UT-100Si, UT-100Si-HK, UT-100Si-TC or UT-100SiK handpiece must be purchased separately.

Which tip version should I choose for my UT-100Si handpiece?

Select the 70-01-13 model with 0.5 mm chisel profile; it is built for the UT-100Si series and operates up to 932 Degrees F.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.