We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Steel magnetic sheet separator, rectangular body, silver finish, 15 inch height

Mag-Mate

Mag-Mate MGF15 Magnetic Sheet Separator 12-22ga 15-1/4H height

SKU CH-AJSN-FEN9V

Separates stacked steel sheets from 22 to 12 gauge with a 15-1/4 inch height and three inch maximum stack

  • Separates thin sheets cleanly with 22-gauge minimum capacity
  • Handles thick stock up to 12-gauge maximum thickness
  • Stands 15-1/4 inches tall for easy access
  • Operates from -148 °F to 480 °F extremes
  • Steel construction resists wear in daily shop use

Mag-Mate MGF15 Sheet Separator

The Mag-Mate MGF15 separates ferrous sheets ranging from 12 gauge down to 22 gauge. It handles stacks up to three inches high and sheets at least five inches wide. The unit suits metal fabrication shops and maintenance crews who need single-sheet feeding without manual prying.

Installation and common issues

Mount the steel body on a flat surface using the integral flanges; the overall footprint is six and a quarter inches wide by two and eleven-sixteenths inches deep. No electrical hookup is required because the magnet is permanent. The most frequent problem occurs when sheets thinner than 22 gauge or thicker than 12 gauge fail to release cleanly.

Pre-order checks

Verify that your material is ferrous and falls within the 12 to 22 gauge range. Confirm the stack height does not exceed three inches and that each sheet is at least five inches wide. Ensure the operating environment stays between minus 148 degrees F and 480 degrees F.

Highlights

  • Separates thin sheets cleanly with 22-gauge minimum capacity
  • Handles thick stock up to 12-gauge maximum thickness
  • Stands 15-1/4 inches tall for easy access
  • Operates from -148 °F to 480 °F extremes
  • Steel construction resists wear in daily shop use

Specifications

BrandMAG-MATE

Questions about this item

How can I confirm the Mag-Mate MGF15 is separating sheets correctly after setup?

The unit separates sheets up to 3 in stack height across the 12 to 22 gauge range, so a clean single-sheet lift with no double feeds shows it is working.

What comes with the Mag-Mate MGF15 and what must I source separately?

The separator itself is supplied; mounting hardware, shims or a support frame for your specific line are not included.

Which gauge capacity should I choose for 16 ga steel sheets?

The MGF15 handles 12 through 22 gauge, so 16 ga falls within the supported range.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.