Lincoln Electric
Lincoln Electric ED030631 MIG Welding Wire L-56 .030
MIG welding wire for carbon steel, AWS ER70S-6 classification with .030 inch diameter and tensile strengths of 81 to 84 ksi depending on shielding gas
- TypeWelding Supplies
- AWS ER70S-6 classification suits general carbon-steel MIG work
- 03 in diameter feeds smoothly through standard guns
- Tensile strength reaches 84 ksi with 90 % argon / 10 % CO2 mix
- Minimum yield strength of 58 ksi meets structural requirements
- Lincoln Electric brand trusted for consistent weld quality
Lincoln Electric L-56 MIG Wire .030
This Lincoln Electric L-56 MIG welding wire carries AWS classification ER70S-6 for carbon-steel GMAW work. The .030 inch diameter suits general fabrication, automotive repair and light structural jobs where solid wire is preferred.
Check shielding gas and wire feed setup
Verify that your MIG gun liner, drive rolls and contact tip match the .030 inch diameter before ordering. The wire is rated for 100 percent carbon dioxide, 75/25 argon/CO2, 90/10 argon/CO2 and 98/2 argon/oxygen mixes, so confirm your gas supply matches one of these blends.
Tensile strength varies with gas mix
As-welded tensile strength ranges from 81 ksi with straight CO2 to 84 ksi with 90/10 argon/CO2, while minimum yield strength is 58 ksi across all listed gases. Selecting the appropriate shielding gas therefore directly changes the mechanical properties of the finished weld.
Highlights
- AWS ER70S-6 classification suits general carbon-steel MIG work
- 03 in diameter feeds smoothly through standard guns
- Tensile strength reaches 84 ksi with 90 % argon / 10 % CO2 mix
- Minimum yield strength of 58 ksi meets structural requirements
- Lincoln Electric brand trusted for consistent weld quality
Specifications
| Brand | LINCOLN ELECTRIC |
|---|---|
| Type | Welding Supplies |
Questions about this item
Does the Lincoln Electric ED030631 spool include a contact tip or do I need to buy one separately?
The spool supplies only the 0.03 in carbon-steel wire classified as ER70S-6; contact tips, liners and shielding gas must be purchased separately.
Should I choose the 0.03 in diameter or a thicker wire for my MIG welder?
The 0.03 in diameter suits light-gauge sheet metal and lower-amp machines; thicker wires require higher amperage and are not interchangeable with this spool.
What does the 81 ksi tensile strength mean when I weld with 100 percent carbon dioxide?
With pure CO2 shielding the deposited weld metal delivers a minimum tensile strength of 81 ksi and a yield strength of 58 ksi.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
SIEMENS
SIEMENS 52PP2D2AB 30 mm Illuminated Push Button Red 24 V LED 1NO/1NC
$179.99
0.00212445BTC
In stock