We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Nylon web safety halter, choker ends, 44 in overall length

Lift-all

Lift-all HH244 Hose Halter 44 in

SKU CH-7HSF-8P47G

A 44-inch nylon safety halter that secures hydraulic, pneumatic or water hose from 1 to 4 inches ID to a 52,000 psi rating

  • Secures hoses up to 4 in ID with choker end
  • 44 in overall length provides extended reach for safety
  • Two-ply nylon construction resists wear on hydraulic and pneumatic lines
  • Rated to 52 000 psi at 1/4 in ID for high-pressure protection
  • Meets Canada OHS and OSHA standards for workplace compliance

Safety halter for hydraulic and pneumatic lines

The Lift-all HH244 is a web safety halter designed to restrain hydraulic hose, pneumatic hose or water hose with inside diameters between 1 in and 4 in. It provides a choker-style connection between two hose assemblies or between a hose and a fixed point, meeting Canada OHS and OSHA requirements for whip-check protection.

Two-ply nylon webbing with choker end fitting

The halter uses two plies of nylon webbing cut to an overall length of 44 in and terminates in a choker end that tightens around the hose when tension is applied. This construction resists abrasion and allows quick installation without tools, so operators can secure lines during daily set-up and remove them just as fast when the job is done.

Rated for 52,000 psi at 1/4 in ID

The assembly is tested to 52,000 psi at a quarter-inch inside diameter, and the allowable pressure changes with the hose bore used. In normal service the nylon webbing remains flexible, produces no mechanical noise and adds negligible weight to the line, letting the halter do its job without affecting system performance.

Highlights

  • Secures hoses up to 4 in ID with choker end
  • 44 in overall length provides extended reach for safety
  • Two-ply nylon construction resists wear on hydraulic and pneumatic lines
  • Rated to 52 000 psi at 1/4 in ID for high-pressure protection
  • Meets Canada OHS and OSHA standards for workplace compliance

Specifications

BrandLIFT-ALL

Questions about this item

What is the maximum hose pressure rating for the HH244 at the minimum inside diameter?

The HH244 is rated for a maximum hose pressure of 52,000 psi at a 1/4 in ID; the rating varies depending on the hose inside diameter.

What are the minimum and maximum hose inside diameters this halter fits?

This halter fits hoses with an inside diameter ranging from a minimum of 1 in to a maximum of 4 in.

How do you install the choker end type on a hose assembly?

Pass the choker end around the hose, thread the opposite end through the loop to form a girth hitch, and pull tight to secure the halter.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.