Lift-all HH230 Hose Halter Nylon Web 30 in

Hose Halter for Hydraulic and Pneumatic Lines

The Lift-all HH230 is a nylon web safety halter designed to restrain hydraulic, pneumatic or water hoses with inside diameters from one-quarter inch up to two inches. It installs as a choker-style whip check between two hose ends to limit whip if a coupling fails or a line bursts. The thirty-inch overall length suits typical industrial hose assemblies in maintenance shops and field service trucks.

Pressure Rating Varies With Hose Bore

The halter is rated for a maximum of fifty-two thousand psi when used on a one-quarter-inch inside diameter hose, but that figure drops as the hose bore increases. No single pressure limit applies across the full diameter range, so the installer must verify the actual rating for the specific hose size in use. The two-ply nylon web meets Canadian OHS and OSHA standards for hose-to-hose restraint.

Thirty-Inch Length Covers Common Coupling Spans

At thirty inches the halter spans the gap between most adjacent couplings on standard workshop hose reels and mobile rigs. It will not reach widely spaced connections or accommodate oversized flange sets, so longer restraints are needed for those layouts. The choker end type fits a broad range of hose outer diameters without requiring separate sizing for each line.