We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Eight silver 3.5 inch SATA IDE adapters in a row

Koss

Koss 8-pack 3.5" IDE adapter SATA

SKU CH-0EN8-H3KYC

Eight 3.5-inch IDE adapters with SATA interface for Kanguru duplicator models

  • Fits KCLONE-7HDs-PRO duplicators with one pack
  • Supports KCLONE-15HDS-PRO systems using two packs
  • Compatible with KCLONE-23HDS-PRO towers via three packs
  • Uses 3.5 inch SATA interface for drive connection
  • New KANGURU hardware listed June 14 2025

Koss 8-pack IDE adapter SATA

This eight-pack supplies the 3.5" IDE adapters required by Kanguru KCLONE-HDS-PRO duplicators. Each pack fits directly into the drive bays so the host can address SATA drives through the native IDE interface. Buyers who need a different form factor or a larger quantity than eight adapters will not be served by this listing.

Thermals noise and power

The adapters are passive devices that draw no additional power beyond what the duplicator supplies to the drive. They add no fan noise and generate no measurable heat of their own during normal cloning operations. No active cooling or external power brick is involved.

Build quality and connectors

Each adapter uses a standard 3.5" mounting frame with a SATA data and power receptacle on the rear. The rigid frame aligns with the duplicator bay rails for tool-free insertion and secure retention. The SATA connector orientation follows the host bay layout so cables route cleanly without strain.

Highlights

  • Fits KCLONE-7HDs-PRO duplicators with one pack
  • Supports KCLONE-15HDS-PRO systems using two packs
  • Compatible with KCLONE-23HDS-PRO towers via three packs
  • Uses 3.5 inch SATA interface for drive connection
  • New KANGURU hardware listed June 14 2025

Specifications

BrandKANGURU

Questions about this item

How do I install the 3.5" IDE adapter into a KCLONE-15HDS-PRO duplicator, and what step is often missed?

Slide each adapter into a drive bay until the SATA connector seats firmly; the step often missed is securing the adapter with the bay retention screw so it cannot shift during cloning.

What maintenance or replacement will the 3.5" IDE adapter need after repeated cloning cycles?

Inspect the SATA data and power contacts for bent pins or debris after every 14 to 15 high-volume runs; replace any adapter showing worn contacts to avoid read errors.

What limit appears first when the 3.5" IDE adapter is used continuously in a KCLONE-23HDS-PRO?

The SATA interface throughput ceiling is reached before the duplicator controller, capping sustained transfer speed during 23-drive simultaneous operations.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.