We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Two black plastic flip-key fob shells with five buttons each, uncut metal blades, key rings and two mini screwdrivers

Key Fob Shell 5 Button 2 Pack Chevrolet GMC Buick 2010-2017

SKU CH-4SG3-J77W4

Two replacement key fob shells with uncut blades, keychains and screwdrivers for 2010-2017 Chevrolet, GMC and Buick models

  • Fits Chevrolet, GMC and Buick models 2010 to 2017
  • Two complete shells with uncut blades and keychains included
  • Reuses your original electronics so no programming is needed
  • 1:1 mould match keeps buttons responsive and signal strong
  • ABS plastic and metal construction with screw reinforcement for durability

Replacement shell for GM five-button remotes

This two-pack supplies new ABS-plastic-and-metal cases that fit Chevrolet Cruze 2010-2016, Camaro 2010-2016, Impala 2014-2017, Equinox 2010-2016, GMC Terrain 2010-2021, Buick LaCrosse 2010-2016, Regal 2011-2017, Verano 2012-2017, Encore 2014-2021 and Allure 2010-2012. Each shell matches the original 1:1 mould and accepts the existing FCC ID OHT01060512 or V2T01060512 electronics.

Thermals noise and power draw

The shell contains no battery, circuit board or transponder chip, so it adds no electrical load, generates no heat and produces no audible noise during normal vehicle operation. Moving the original internals into the new case does not change the remote's power consumption or thermal behaviour.

Included hardware and installation impact

Two uncut key blades, two key chains, one 2.0 mm Phillips screwdriver and one small flat-head screwdriver are bundled for immediate transfer of the original electronics. The uncut blades require professional cutting to match the vehicle, and the supplied drivers simplify the clip-plus-screw assembly without glue. Builders needing pre-cut blades or pre-programmed electronics must source those separately.

Highlights

  • Fits Chevrolet, GMC and Buick models 2010 to 2017
  • Two complete shells with uncut blades and keychains included
  • Reuses your original electronics so no programming is needed
  • 1:1 mould match keeps buttons responsive and signal strong
  • ABS plastic and metal construction with screw reinforcement for durability

Specifications

Part NumberJJCHQ-A9-XFLkeycase5

Questions about this item

How do I move my transponder chip and circuit board into the new shell using the 2.0 mm Phillips screwdriver?

Remove the four small screws from the original fob with the supplied 2.0 mm Phillips driver, transfer the board, battery and transponder into the new ABS shell, then refit the same screws — the mould matches the original exactly.

What will need replacement after the shell is fitted?

The uncut blade must be cut once by a locksmith or dealer to match the vehicle; the ABS case and five buttons require no scheduled replacement.

What is the first limitation during daily use?

The 1.8 cm thickness and 3.5 cm width add minimal bulk, but the uncut blade cannot start the vehicle until it is professionally cut.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.