We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Three copper braid spools and two flux paste tubes, 10 ft total length, 0.1 inch width

KELLYSHUN Solder Wick 10Ft 0.1 inch 3 Piece Flux 2 Piece Braid

SKU CH-6TTB-05PH1

Desoldering kit with 10 ft of 0.1 inch copper braid and three flux pieces for clean PCB rework

  • Compatibility/FitmentOut-Opening, Narrow Stile, Store Front Doors
  • 100% copper braid conducts heat fast for strong capillary action
  • 1 inch width fits narrow joints on small PCB boards
  • No-clean flux leaves non-conductive, non-corrosive residue
  • 10 ft total length covers multiple rework sessions
  • Three flux pieces and two braid pieces included for versatile use

Solder Wick Kit for PCB Rework

This kit supplies ten feet of 0.1 inch copper desoldering braid across two spools plus three no-clean flux pens. It serves technicians, hobbyists and students who need to remove excess solder from through-hole and surface-mount joints on printed circuit boards.

Braid Width Decides Joint Access

The 0.1 inch wide braid fits standard pad pitches on most consumer and automotive electronics. Wider braid would bridge adjacent pads on dense boards; narrower braid would lack the capillary volume for larger power or ground connections.

Copper Braid Draws Heat Fast

Fine flat-stitch copper weaving conducts heat quickly into the braid so solder wicks away in seconds with a standard iron. The no-clean flux leaves only non-conductive, non-corrosive residue that does not require post-rework cleaning.

Highlights

  • 100% copper braid conducts heat fast for strong capillary action
  • 1 inch width fits narrow joints on small PCB boards
  • No-clean flux leaves non-conductive, non-corrosive residue
  • 10 ft total length covers multiple rework sessions
  • Three flux pieces and two braid pieces included for versatile use

Specifications

Compatibility/FitmentOut-Opening, Narrow Stile, Store Front Doors

Questions about this item

How much desoldering length does the 10 ft roll provide for typical board work?

The roll gives 10 ft of 0.1 inch wide copper braid, enough for many joint clean-ups on small PCBs before needing a fresh section.

What does the no-clean flux leave behind after desoldering?

The flux residue is non-conductive and non-corrosive, so it can stay on the board without cleaning and will not affect circuit operation.

Will the 0.1 inch braid fit between tight through-hole pins on dense boards?

At 0.1 inch wide the fine flat-stitch copper braid slips between closely spaced pins and uses capillary action to pull solder clear.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.