KEHIPI
KEHIPI P1520 electrician tool 5 pcs 20 AWG 50 cm
A set of five coloured silicone test leads with dual IC hook clips for low-current circuit testing
- Copper alloy hooks deliver strong conductivity and resist bending
- Silicone leads stay flexible across temperature extremes for long service life
- Five colour-coded cables simplify identification during low-current testing
- 50 cm length and 20 AWG gauge suit bench, lab and phone repair work
- Dual IC hook clips grip small component pins securely for precise measurements
Compact test hook clips for low current work
The KEHIPI P1520 set supplies five coloured hook clips on 50 cm silicone leads rated at 20 AWG. Copper alloy hooks give firm contact on dense boards while the soft insulation stays flexible across temperature extremes. Technicians, students and hobbyists use them for IC level checks, phone repair and bench prototyping where space is tight.
Cool running and quiet by nature
Passive copper alloy clips and silicone wire add no active heat or noise to the test bench. The 20 AWG conductors handle the low current signals typical of logic and sensor probing without measurable voltage drop. No fan, pump or power supply is involved so the kit draws zero power and adds no acoustic load to a quiet lab.
Plug in and probe without extra hardware
Each lead terminates in a standard hook that slips onto multimeter probes, oscilloscope inputs or bare header pins. The 50 cm length reaches across a typical bench while the five colours keep signal, ground and data lines straight. No adapters, drivers or software are required; the clips free up both hands for soldering or firmware work.
Highlights
- Copper alloy hooks deliver strong conductivity and resist bending
- Silicone leads stay flexible across temperature extremes for long service life
- Five colour-coded cables simplify identification during low-current testing
- 50 cm length and 20 AWG gauge suit bench, lab and phone repair work
- Dual IC hook clips grip small component pins securely for precise measurements
Specifications
| Brand | Goupchn |
|---|---|
| Model | P1520 |
Questions about this item
How do I connect the 20 AWG silicone leads to a multimeter without shorting adjacent pins?
Push each dual IC hook onto the test point first, then plug the 4 mm banana into the meter; the 50 cm silicone gives enough slack to route away from neighbouring pins.
When will the copper-alloy hooks or silicone insulation need replacement?
Replace a lead if the hook tip bends permanently or the silicone shows cracks; both materials withstand repeated low-current use but fatigue after many insertions.
What maximum current can the 20 AWG wires carry continuously before heating becomes an issue?
The 20 AWG silicone leads are rated for low-current testing only; sustained loads above a few hundred milliamps will cause noticeable warming.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
SIEMENS
SIEMENS 52PP2D2AB 30 mm Illuminated Push Button Red 24 V LED 1NO/1NC
$179.99
0.00215055BTC
In stock