We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Pair of red and black alligator clip test leads 3.3ft long with insulated jaws

KEHIPI

KEHIPI P1024 alligator clip test leads 1000V 15A 3.3ft 2pcs

SKU CH-4ERE-8YQ97 MPN P1024

A pair of dual-ended alligator-clip test leads rated 1000 V and 15 A, each 3.3 ft long with 10 mm jaw opening for secure circuit connections

  • Pure copper clips handle 1000 V and 15 A for safe high-power testing
  • 10 mm jaw opening grips terminals up to 10 mm wide without slipping
  • Strong internal spring keeps clamping force consistent after repeated use
  • 3 ft flexible leads give room to reach across engine bays or benches
  • Red and black pair simplifies polarity identification during circuit checks

Dual-ended alligator test leads

KEHIPI P1024 test leads ship as a new pair of 3.3 ft cables with pure copper alligator clips at both ends. Each clip opens to a maximum width of 10 mm and is rated for 1000 V and 15 A continuous current.

Suited for general electrical testing

These leads suit technicians and hobbyists performing circuit checks on automotive accessories, vintage cars, trucks or motorcycles where the protected circuit uses a 15 A fuse or smaller. They are not for buyers who need higher current capacity, longer reach or specialised probe tips.

Behaviour under sustained load

The rubber insulation layer prevents the clips from slipping during extended contact, and the spring retains its tension without deforming over repeated use. The firm wire-to-clip junction maintains a stable connection throughout long test sessions.

Highlights

  • Pure copper clips handle 1000 V and 15 A for safe high-power testing
  • 10 mm jaw opening grips terminals up to 10 mm wide without slipping
  • Strong internal spring keeps clamping force consistent after repeated use
  • 3 ft flexible leads give room to reach across engine bays or benches
  • Red and black pair simplifies polarity identification during circuit checks

Specifications

BrandGoupchn
ModelP1024

Questions about this item

Do I need a multimeter or other instrument with banana-plug or probe inputs to use the KEHIPI P1024 test leads?

Yes — the leads terminate in alligator clips, so you must connect them to a meter, power supply or tester that accepts banana plugs or bare probes.

Will the 10 mm maximum jaw opening grip the smaller terminals found on vintage automotive wiring?

The 10 mm opening is wide enough for most vintage car, truck and motorcycle terminals; the strong spring holds securely on thinner posts.

How can I verify the leads are conducting properly after I attach them?

Measure a known voltage source with your multimeter; a stable reading at or below 1000 V and 15 A confirms the copper clips and 3.3 ft cable are intact.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.