We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Hakko T9-L2 chisel tip, 2 mm wide, silver metal finish

Hakko

Hakko T9-L2 Chip 2L (0.08) Soldering Tip

SKU CH-W733-8VMX2

Chisel tip for FM-2023 desoldering tweezers, 2 mm width, rated to 400 °C for FM-203 and FM-206 stations

  • TypeSolders & Supplies
  • Precise chip-component removal with 0.08 mm fine chisel tip
  • Chisel profile delivers focused heat on 2 mm width for clean joints
  • Works with FM-2023 handpiece on FM-203 and FM-206 stations
  • Rated for 400 °C maximum temperature for demanding desoldering tasks
  • Two tips per pack ensures a spare is always ready

Hakko T9-L2 Chip 2L (0.08) Tip

This Hakko T9-L2 Chip 2L (0.08) is a desoldering tweezer tip designed for rework stations. It suits technicians performing precision component removal on circuit boards. The tip works with compatible Hakko handpieces and stations for controlled desoldering tasks.

Chisel tip, 2 mm width, 0.08 size

The single specification that decides fit is the chisel tip profile measuring 2 mm in width and designated 0.08. It is built for the FM-2023 handpiece and works with FM-203 and FM-206 stations at up to 400 degrees C. Verify your handpiece model before ordering.

Direct handpiece fit, check station compatibility

Installation is a direct fit onto the FM-2023 handpiece with no tools required. What usually goes wrong is fitting it to an incompatible handpiece or exceeding the 400 degrees C maximum operating temperature. Confirm your station model is FM-203 or FM-206 to avoid damage.

Highlights

  • Precise chip-component removal with 0.08 mm fine chisel tip
  • Chisel profile delivers focused heat on 2 mm width for clean joints
  • Works with FM-2023 handpiece on FM-203 and FM-206 stations
  • Rated for 400 °C maximum temperature for demanding desoldering tasks
  • Two tips per pack ensures a spare is always ready

Specifications

BrandHakko
TypeSolders & Supplies

Questions about this item

What does the 0.08 designation tell me about the tip once it is installed on the FM-2023 handpiece?

The 0.08 marking identifies this as a 2 mm wide chisel tip for the FM-2023 desoldering tweezer, giving a broad contact area for chip removal.

Which stations does the FM-2023 interface support, and what temperature ceiling does that impose?

The tip works with FM-203 and FM-206 stations, which limit operation to a maximum of 400 degrees Celsius.

What physical dimensions must the work area accommodate for this tip to fit?

The chisel tip measures 2 mm in width and 2 mm in outside diameter, so the component pads need at least that much clearance.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.