We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Stainless steel hydraulic punch sleeve, cylindrical, brushed finish

Greenlee

Greenlee 1557SS Hydraulic Punch Sleeve 10 ga SS

SKU CH-F54V-3GMFV MPN 1557SS

Stainless-steel hydraulic punch sleeve punches clean holes up to 10 ga mild steel and fits Greenlee 745 punch units and 7308 punch kits

  • TypeHand Held Punches
  • Clean, accurate holes in stainless steel
  • 10 gauge mild steel maximum capacity
  • 65 inch exterior diameter for precise fit
  • Compatible with Greenlee 745 punch units
  • Works with Greenlee 7308 punch kits

Hydraulic punch sleeve for 10 ga mild steel

The Greenlee 1557SS is a stainless-steel sleeve designed to cut clean, accurate holes in material up to 10 gauge mild steel. It measures 1/8" x 2.65" in exterior diameter and is built for use with hydraulic punch drivers. The tool targets electricians, maintenance crews and metal fabricators who need repeatable hole quality in the field or shop.

Compatibility with Greenlee 745 and 7308 units

This sleeve fits Greenlee model 745 punch units and model 7308 punch kit units, so buyers already owning that hardware can add the 1557SS directly. It will not work with punch systems from other brands or with Greenlee units outside the listed models. Users needing a different hole size or a non-hydraulic method should look at other tooling.

Maximum capacity 10 gauge mild steel

The single specification that decides fit is the 10 gauge mild-steel rating; material thicker than that exceeds the sleeve's design limit. If the job requires punching heavier plate, a larger-capacity sleeve or a different punching system is required. No other specification overrides this capacity constraint.

Highlights

  • Clean, accurate holes in stainless steel
  • 10 gauge mild steel maximum capacity
  • 65 inch exterior diameter for precise fit
  • Compatible with Greenlee 745 punch units
  • Works with Greenlee 7308 punch kits

Specifications

BrandGreenlee
Model1557SS
TypeHand Held Punches

Questions about this item

What punch units does the Greenlee 1557SS sleeve fit?

The sleeve is compatible with Greenlee Mfg No 745 Punch Units and 7308 Punch Kit units, so it mounts directly on those hydraulic drivers.

How do you install the sleeve on a Greenlee 745 or 7308 punch unit, and what step is often missed?

Slide the sleeve over the punch body until it seats against the die holder, then tighten the set screw; the step people miss is confirming the sleeve sits flush before locking it down.

When should the stainless steel sleeve be replaced?

Replace the sleeve when the 1/8" x 2.65" exterior shows visible wear, deformation or corrosion that prevents clean 10 ga. mild steel punching.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.