We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Orange and yellow insulated 1/4 inch drive 12 point socket P1505

Gray Tools

Gray Tools V108-I 1/4" 12 Point 1000V Insulated tool storage

SKU CH-05DN-0D6YF

Holds a 1/4" 12-point insulated socket tested to ASTM F1505 for 1000 V protection with dual-layer safety indication

  • 12-point drive engages fasteners securely
  • Dual-layer insulation protects up to 1000 V
  • Yellow inner layer reveals wear instantly
  • Tested to ASTM F1505 for verified safety
  • 1/4-inch hex fits standard sockets

Insulated 12-point socket

The Gray Tools V108-I is a 1/4-inch drive socket with a 12-point opening for standard fasteners. It is built for electricians and maintenance technicians who work on or near live circuits up to 1000 volts. Each piece is individually insulated and tested to ASTM F1505 standards. The tool is not suited for buyers who need impact-rated sockets or larger drive sizes.

Thermals noise and power

As a hand tool, the socket generates no heat, noise or electrical draw during use. The dual-layer insulation uses an orange outer layer over a yellow inner layer that acts as a visual safety indicator; if the yellow becomes visible the insulation is compromised. No external power source or cooling is required. The product carries California Proposition 65 warnings for chemicals known to cause cancer and reproductive harm.

Insulation testing and safety marking

Every socket is tested to ASTM F1505 before it leaves the factory, confirming the 1000 V protection rating. The two-colour insulation system lets the user verify integrity at a glance without additional instruments. No software, calibration certificates or accessories are bundled with the tool. Buyers who require a full insulated set or a storage case must source those items separately.

Highlights

  • 12-point drive engages fasteners securely
  • Dual-layer insulation protects up to 1000 V
  • Yellow inner layer reveals wear instantly
  • Tested to ASTM F1505 for verified safety
  • 1/4-inch hex fits standard sockets

Specifications

BrandGRAY TOOLS

Questions about this item

How is the 12-point insulated socket installed onto a 1/4" drive, and what step is often missed?

Align the 12-point opening with the fastener, press the 1/4" hex drive squarely into the ratchet until the detent engages, then verify the orange outer insulation and yellow inner indicator layer are both intact before applying voltage.

What maintenance or replacement will the V108-I insulated socket need over time?

Inspect the dual-layer insulation before each use; if the yellow safety-indicator layer becomes visible through cuts, abrasion or compression of the orange outer layer, remove the socket from service and replace it.

What limit appears first when the 1000 V insulated socket is used continuously under load?

The ASTM F1505-rated insulation is the limiting factor; once the yellow indicator layer shows through the orange layer, the socket no longer provides certified 1000 V protection and must be replaced.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.