We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Eaton 30mm green flush push button with chrome bezel

Eaton

Eaton 10250T103-2 Cutler-Hammer 30mm Green Push Button

SKU CH-CF0E-DR8KR

A 30 mm momentary push button with green metal head, 2NO contacts rated 10A at 600V AC, NEMA 1, 2, 3, 3R, 4, 4X, 12, 13 and IP65 sealing

  • Engine BrandEATON
  • Engine Size30 mm
  • 30 mm flush mount fits standard panels
  • Momentary action gives instant control response
  • IP65 rating resists dust and water jets
  • 10 A at 600 V AC handles heavy loads
  • CE CSA UL listed meets safety standards

30 mm Green Industrial Push Button

The Eaton 10250T103-2 is a flush-mount momentary push button designed for 30 mm panel cut-outs. It carries a 10 A contact rating at 600 V AC with a 2NO contact form and screw-clamp terminals for secure wiring. The metal head and chrome-plated zinc die-cast bezel provide mechanical durability in control-panel environments. NEMA 1, 2, 3, 3R, 4, 4X, 12, 13 and IP65 ratings confirm suitability for indoor and outdoor industrial use.

Suited for control panels needing a single green

This unit fits panels drilled for 30 mm operators and supplies two normally-open contacts for start or interlock circuits. Installers requiring illuminated indication, maintained action, different contact configurations or a smaller cut-out diameter should select an alternative operator. The lack of a legend plate means custom labelling must be sourced separately.

Diaphragm seals and drainage holes protect contacts

Enclosed silver contacts with reliability nibs resist contamination while the diaphragm seal and drainage holes shed moisture in wash-down areas. A grounding nib on the bezel simplifies panel bonding. Supplied hardware is limited to the operator body; mounting nuts, legend plates or additional contact blocks are not included. CE, CSA and UL listings support compliance in regulated installations.

Highlights

  • 30 mm flush mount fits standard panels
  • Momentary action gives instant control response
  • IP65 rating resists dust and water jets
  • 10 A at 600 V AC handles heavy loads
  • CE CSA UL listed meets safety standards

Specifications

Engine BrandEATON
Engine Size30 mm

Questions about this item

What enclosure or panel cut-out is required to mount this 30 mm flush push button?

A 30 mm panel cut-out and an enclosure rated at least NEMA 1, 2, 3, 3R, 4, 4X, 12 or 13 with IP65 ingress protection are needed for proper installation.

Will the screw-clamp terminals on this operator accept the same wire gauges as older Cutler-Hammer 10250T series buttons?

The screw-clamp terminals are designed for standard industrial wiring used with the 10250T series, so existing field wiring can be reused without modification.

How can I verify the momentary action and 10 A, 600 V AC rating are functioning after wiring the 2NO contacts?

Press the green flush button; the circuit should close only while pressure is applied. A continuity test across each normally-open contact confirms the 10 A, 600 V AC rating is active.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.