We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Silver cylindrical annular cutter with pilot pin visible

Drill America

Drill America DWC5-530-133 annular cutter 1 inch pneumatic accessory

SKU CH-C0CA-8T974

A high-speed steel annular cutter with pilot pin for fast, efficient hole making in magnetic drill presses only

  • Fast, efficient hole making with high-speed steel construction
  • Hardness and toughness combine for wear resistance in general use
  • Cuts only material needed to produce a quality hole
  • 3/4" Weldon shank fits magnetic drill press only
  • California Proposition 65 warning for cancer and reproductive harm

Drill America HSS annular cutter

Drill America DWC5-530-133 is a high-speed steel annular cutter built for fast, efficient hole making with a magnetic drill press. It cuts only the material needed to produce a quality hole and includes a pilot pin for accurate starts. The tool has a 3/4 inch Weldon shank that fits compatible magnetic drill presses.

For magnetic drill press operators only

This cutter suits users who work with a magnetic drill press and need a 1 inch diameter high-speed steel cutter for general purpose metal cutting. It is not for anyone who plans to use a standard hand drill, a conventional drill press or any machine without a 3/4 inch Weldon shank interface.

3/4 inch Weldon shank requirement

The single specification that decides fitment is the 3/4 inch Weldon shank, which only works with a magnetic drill press. If your equipment does not accept this shank, the cutter cannot be used and a different tooling interface is required.

Highlights

  • Fast, efficient hole making with high-speed steel construction
  • Hardness and toughness combine for wear resistance in general use
  • Cuts only material needed to produce a quality hole
  • 3/4" Weldon shank fits magnetic drill press only
  • California Proposition 65 warning for cancer and reproductive harm

Specifications

BrandDRILL AMERICA

Questions about this item

How do I fit the DWC5-530-133 annular cutter onto my magnetic drill press?

Slide the 3/4 inch Weldon shank into the press arbor until the flat seats, then tighten the grub screws; the step people miss is inserting the supplied pilot pin before locking the cutter.

What part of the DWC5-530-133 will need replacing first with regular use?

The pilot pin wears faster than the high-speed steel teeth, so keep spares and swap it when the tip rounds over or the cutter stops self-centring.

What limits how long I can run the DWC5-530-133 continuously in thick steel?

Heat builds in the high-speed steel body because the cutter only removes a thin ring of material; pause to let it cool and apply cutting fluid before the teeth lose hardness.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.