We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
A bright, uncoated solid carbide jobber drill bit, size 34, 2.25 inches long with spiral flutes and round shank

Drill America

Drill America DMOD34 Solid Carbide Jobber Drill Bit #34 2.25

SKU CH-BG95-PVZGC

A solid carbide jobber drill bit for abrasive materials, uncoated with a 118-degree point and round shank

  • Solid carbide construction resists wear in abrasive materials
  • 118-degree conventional point provides accurate hole starts
  • Uncoated bright finish suits cast iron and non-ferrous alloys
  • Round shank fits standard drill chucks without slippage
  • Jobber length of 2.25 inches balances rigidity and reach

#34 Solid Carbide Jobber Drill

The Drill America DMOD34 is a solid carbide jobber drill bit sized #34 with an overall length of 2.25 inches. It features an uncoated bright finish, a round shank, and spiral flutes with a 118 degree conventional point. The flute length measures 1-1/4 inches for effective chip removal.

Ideal for abrasive and high-temperature drilling

This bit suits workshops drilling cast iron, non-ferrous alloys, high-silicon aluminium, copper, plastics, bronze, hard rubber, or plexiglass where accuracy must be maintained. It is not for buyers who need a coated tool for extended life in ferrous metals, nor for operators requiring a split-point geometry to reduce walking on hard steel.

Check shank compatibility and material match

Verify that your drill chuck or collet accepts a round shank of this diameter before ordering. Confirm the workpiece material matches the recommended abrasive and non-ferrous range listed. Note the California Proposition 65 warning regarding cancer and reproductive harm.

Highlights

  • Solid carbide construction resists wear in abrasive materials
  • 118-degree conventional point provides accurate hole starts
  • Uncoated bright finish suits cast iron and non-ferrous alloys
  • Round shank fits standard drill chucks without slippage
  • Jobber length of 2.25 inches balances rigidity and reach

Specifications

BrandDRILL AMERICA

Questions about this item

What size drill chuck do I need to hold the #34 round shank?

The bit has a round shank sized for a #34 drill, so a chuck that closes down to at least 2.25 mm will grip it securely.

Can I run this solid carbide bit in the same hand drill I use for high-speed steel twist bits?

Yes, the 118-degree conventional point and round shank let it fit standard drill chucks, but carbide is more brittle so use steady pressure and avoid side loads.

How can I confirm the bit is cutting correctly in cast iron or bronze after I start drilling?

You should see short, curled chips and a clean hole diameter matching the #34 size without excessive heat or chatter at the cutting edges.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.