Drill America
Drill America DAM24X3/8 Carbide-Tipped Masonry Drill Bit 24
Carbide-tipped masonry bit with wide flutes for fast dust removal in brick, concrete and sandstone at 24" length
- TypeDrill Accessories
- Carbide-tipped construction resists wear in hard masonry
- 24-inch overall length reaches deep holes without extensions
- 118-degree conventional point starts accurately in brick and concrete
- Black oxide finish reduces corrosion on the steel body
- Wide spiral flutes clear dust quickly for faster drilling
Carbide-Tipped Masonry Bit
The Drill America DAM24X3/8 is a carbide-tipped masonry drill bit built for professionals and DIY users who need to bore deep holes in brick, concrete and sandstone. Its 24 inch overall length provides the reach required for through-wall anchoring and renovation tasks where standard bits fall short.
Black Oxide Finish & Round Shank
A black oxide coating reduces corrosion and helps the bit run cooler during extended drilling sessions. The 3/8 inch round shank fits directly into the chuck of any portable electric drill, so no special adaptors or SDS machines are required on site.
118 Degree Conventional Point
The 118 degree conventional point is optimised for softer masonry materials and centres the bit quickly on hard surfaces. Buyers who need an SDS-plus shank or a split-point geometry for hard aggregate concrete should look elsewhere.
Highlights
- Carbide-tipped construction resists wear in hard masonry
- 24-inch overall length reaches deep holes without extensions
- 118-degree conventional point starts accurately in brick and concrete
- Black oxide finish reduces corrosion on the steel body
- Wide spiral flutes clear dust quickly for faster drilling
Specifications
| Brand | Drill America |
|---|---|
| Type | Drill Accessories |
Questions about this item
What does the 118-degree conventional point mean for drilling speed?
The 118-degree conventional point is designed for general-purpose drilling in brick, concrete and sandstone, providing a balance of centering accuracy and material penetration.
Will the 3/8-inch round shank fit my cordless drill chuck?
The 3/8-inch round shank fits any standard three-jaw chuck that accepts 3/8-inch or larger drill bits, which covers most portable electric drills.
How do I avoid snapping the carbide tip when starting a hole?
Apply steady pressure at low speed until the tip seats, then increase speed; letting the bit wander on the surface before it bites is the most common cause of tip fracture.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
SIEMENS
SIEMENS 52PP2D2AB 30 mm Illuminated Push Button Red 24 V LED 1NO/1NC
$179.99
0.00213167BTC
In stock