We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Diamond Vantage 4 inch depressed center grinding wheel with 5/8 inch unthreaded hole

Diamond Vantage

Diamond Vantage DXA2920P04A Grinding Wheel 4in 24 Grit Depressed Center

SKU CH-4PQE-DQGK0

A 4-inch diamond grinding wheel with 24 grit and Type 29 depressed centre for angle grinders up to 15,300 RPM

  • Diamond abrasive cuts hard metals efficiently
  • Grit 24 removes material quickly on cast iron
  • Type 29 depressed centre suits angle grinders
  • 4 inch diameter fits standard 5/8 inch arbor
  • Rated 15,300 RPM for high-speed grinding

DiamondX Series 4-Inch Grinding Wheel

This DiamondX Series wheel is a 4-inch depressed-center grinding wheel built for angle grinders. It uses a diamond abrasive bonded with a BSL bond and carries a 24-grit rating. The wheel mounts via a 5/8-inch unthreaded hole and is intended for operators cutting and grinding hard metals.

Grit 24 Capacity for Cast Iron and Steel

The 24-grit diamond surface removes material quickly on cast iron, ceramic, stainless steel and steel. It runs at a maximum operating speed of 15,300 RPM, giving high stock removal on those alloys. Finer finishing or work on softer non-ferrous metals will require a different grit or bond.

Depressed Center Mounting for Angle Grinders

The Type 29 depressed centre clears the grinder flange and allows a lower working angle on flat surfaces. A 1/4-inch thickness adds rigidity for straight cuts and bevels. The unthreaded 5/8-inch arbor hole fits standard angle-grinder spindles without adapters.

Highlights

  • Diamond abrasive cuts hard metals efficiently
  • Grit 24 removes material quickly on cast iron
  • Type 29 depressed centre suits angle grinders
  • 4 inch diameter fits standard 5/8 inch arbor
  • Rated 15,300 RPM for high-speed grinding

Specifications

BrandDIAMOND VANTAGE

Questions about this item

Will the 5/8 in unthreaded hole fit the spindle on my older angle grinder?

The wheel uses a 5/8 in unthreaded hole, which matches the standard arbor on most angle grinders; verify your tool's spindle diameter before mounting.

How can I confirm the wheel is running true after I install it?

Run the grinder at no load and watch for wobble; the wheel should spin smoothly up to the 15,300 RPM maximum without vibration.

Does the box include a backing flange or mounting nut for the 5/8 in hole?

Only the 4 in diameter Type 29 depressed-centre wheel is supplied; any required flange or lock-nut must be purchased separately.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.