We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Silver 10-inch grinding head with 10 segments

Diamond Vantage

Diamond Vantage DVCCM1001 Grinding Head 10 Segment 10 In

SKU CH-M2TQ-5DYY4

Ten-segment grinding head with 50-grit diamond segments for medium-bond concrete floor grinding up to 980 rpm

  • Grinds concrete floors efficiently with 10 diamond segments
  • Medium bond hardness balances wear and removal on concrete
  • 50 grit abrasive suits general surface preparation tasks
  • Fits single and dual-head grinders for versatile mounting
  • Clockwise rotation up to 980 RPM for compatible machines

Diamond Vantage 10-Inch Grinding Head

The Diamond Vantage DVCCM1001 is a 10-inch grinding head fitted with ten medium-bond segments. It is built for concrete floor grinding on single or dual-head floor grinders and runs clockwise at speeds up to 980 RPM.

Suited for Concrete Floor Preparation

Contractors preparing concrete, brick or block surfaces will find the 50-grit segments effective for material removal. Operators needing finer finishing grits, counter-clockwise rotation or compatibility with hand-held angle grinders should look at other tooling.

Fits Single and Dual-Head Floor Grinders

The head mounts directly to compatible floor grinding machines and includes all ten segments in one piece. It frees the operator from assembling individual segments and delivers consistent cutting performance across the 10-inch disc diameter.

Highlights

  • Grinds concrete floors efficiently with 10 diamond segments
  • Medium bond hardness balances wear and removal on concrete
  • 50 grit abrasive suits general surface preparation tasks
  • Fits single and dual-head grinders for versatile mounting
  • Clockwise rotation up to 980 RPM for compatible machines

Specifications

BrandDIAMOND VANTAGE

Questions about this item

What type of floor grinder is required to use the DVCCM1001 10-inch grinding head?

This grinding head is designed for use with single-head and dual-head floor grinders that accept a 10-inch disc diameter and clockwise rotation.

Can the 10-segment medium-bond head run on a grinder rated above 980 RPM?

No, the maximum operating speed is 980 RPM; exceeding this limit can cause segment failure or unsafe operation.

How can I confirm the DVCCM1001 is cutting efficiently after installation?

Expect a consistent silver-grey slurry and steady motor load when grinding concrete at 50 grit; uneven wear or vibration indicates misalignment.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.