We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Yellow polyester cross-arm strap with dual steel D-rings and wear pad, 36 in length

DBI/SALA

DBI/SALA 1003000 Cross Arm Strap 36 in 310 lb

SKU CH-TVAJ-A3GJ7

A 36-inch cross-arm strap with dual D-rings and a 310 lb capacity, meeting ANSI Z359.18 and OSHA 1910.140 and 1926.502

  • 36 in length for versatile anchor positioning
  • 310 lb weight capacity supports heavy-duty fall protection
  • Dual D-ring attachment point enables secure tie-off
  • Meets ANSI Z359.18 and OSHA 1910.140 / 1926.502 standards
  • Wear pad included to extend strap service life

Fall-arrest anchor strap for 310 lb capacity

The DBI/SALA 1003000 Cross Arm Strap provides a reusable tie-off anchor with dual D-rings for fall-arrest systems. Its 36 in length suits overhead beams and structural members where a fixed anchor is not available. The polyester webbing and steel D-ring meet ANSI Z359.18 and OSHA 1910.140 and 1926.502 requirements. Workers needing a certified anchor point for personal fall protection use this strap.

Thermal and power behaviour not applicable

This passive webbing strap generates no heat, draws no power and produces no noise during normal use. Performance depends entirely on correct installation around a qualified structural anchor. A wear pad protects the webbing from abrasion at the contact point. Inspection before each use remains the only recurring requirement.

Included wear pad extends webbing life

The sewn-on wear pad reduces cutting and abrasion where the strap bears against steel edges. Dual D-rings allow pass-through choker configuration without extra connectors. No additional hardware, software or cable is supplied with the strap. Users must supply a compatible lanyard or self-retracting lifeline rated for the same 310 lb capacity.

Highlights

  • 36 in length for versatile anchor positioning
  • 310 lb weight capacity supports heavy-duty fall protection
  • Dual D-ring attachment point enables secure tie-off
  • Meets ANSI Z359.18 and OSHA 1910.140 / 1926.502 standards
  • Wear pad included to extend strap service life

Specifications

Brand3M DBI-SALA

Questions about this item

How do I install the 1003000 Cross Arm Strap around a beam and which step is often missed?

Wrap the 36 in polyester webbing around the anchorage, pass the D-ring end through the opposite loop to choke it tight, then clip your lanyard to the exposed D-ring; the step most users skip is pulling the webbing flat so the wear pad sits flush against the structure.

What part of the strap will need inspection or replacement after repeated jobsite use?

Check the 1 3/4 in webbing for cuts, abrasion or UV damage, verify the steel D-ring and stitching show no deformation or corrosion, and confirm the wear pad remains intact; remove the strap from service if any of these conditions appear.

What is the first limit reached when the 1003000 strap is loaded continuously at its rated capacity?

The 310 lb weight capacity is the limiting factor; sustained loads at or above this value require immediate removal from service per ANSI Z359.18 and OSHA 1910.140 / 1926.502.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.