We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Grey metal bar and tube roller with three rollers and hand lever

Dayton

Dayton 45J333 Bar and Tube Roller pneumatic accessory

SKU CH-4MZZ-4Z6H7

Bar and tube roller shapes round tube up to 2 in diameter with three rollers and a hand lever

  • Hand-lever actuation enables controlled manual bending
  • Three rollers grip round tube up to 2 in diameter
  • 20 in minimum bend radius for smooth curves
  • Accepts mild-steel bar up to 1 1/4 in wide
  • Handles pipe up to 1 1/2 in size

Dayton 45J333 Bar and Tube Roller

The Dayton 45J333 is a hand-lever operated bar and tube roller designed for metal fabrication tasks. It forms mild steel stock using three rollers and a gray finish. The tool accepts round tube, pipe and flat bar profiles for bending operations.

Suited for workshop bending of mild steel

This roller suits fabricators who need to curve mild steel tube up to 2 in diameter, pipe up to 1 1/2 in and flat bar up to 1 1/4 in wide. It is not for buyers who require powered actuation, hydraulic force or the ability to bend thicker-walled or harder alloy sections beyond the listed capacities.

Capacity and forming limits

The three-roller configuration handles round tube to 2 in, schedule pipe to 1 1/2 in and flat bar to 1 1/4 in width. A minimum bend radius of 20 in defines the tightest curve achievable without distortion. Material thicker or wider than these limits exceeds the tool’s mechanical range.

Highlights

  • Hand-lever actuation enables controlled manual bending
  • Three rollers grip round tube up to 2 in diameter
  • 20 in minimum bend radius for smooth curves
  • Accepts mild-steel bar up to 1 1/4 in wide
  • Handles pipe up to 1 1/2 in size

Specifications

BrandDAYTON

Questions about this item

What pneumatic supply do I need to run the 45J333 bar and tube roller?

The accessory is a hand-lever actuated rolling tool and does not require a pneumatic supply; it operates by manual force applied to the lever.

Can I keep my existing 1 1/4 inch mild steel bar stock and roll it with this tool?

Yes, the roller accepts a maximum bar width of 1 1/4 in for mild steel, so your current stock fits within the capacity.

How do I verify the 45J333 is forming the correct 20 inch minimum bend radius after setup?

Measure the inside radius of the formed round tube or pipe; it should be no tighter than 20 in, which is the minimum bend radius specified for this three-roller unit.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.