We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Grey plastic control station with black and red start stop push buttons 25mm

Dayton

Dayton 20C793 Industrial Power Supply 25mm Start/Stop Push Button Control Station

SKU CH-QY00-8Q7J9

Two-button control station with maintained start/stop action, 10 A AC contacts and IP40 enclosure

  • Engine BrandDAYTON
  • Engine Size25 mm
  • 25 mm push buttons fit standard industrial panels
  • Start/Stop legend gives clear machine control
  • 10 A AC / 5 A DC contacts handle motor loads
  • IP40 enclosure resists dust in workshop environments
  • Wall mount with 1/2–3/4 in NPT hub simplifies installation

25 mm Start/Stop Control Station

This Dayton 20C793 unit provides a two-operator push-button station for industrial start and stop functions. The 25 mm mounting size suits standard control-panel cut-outs. It is built for wall mounting with a 1/2 in to 3/4 in NPT hub. The enclosure carries a NEMA 1 rating and IP40 ingress protection.

Thermals and electrical rating

Contacts are rated at 10 A at 600 V AC and 5 A at 24 V DC under the A600/P600 designation. The maintained action on both buttons holds the circuit state without continuous pressure. A mechanical interlock prevents simultaneous activation of the start and stop operators. No pilot lights are fitted, so power dissipation remains minimal.

Plastic enclosure and included hardware

The enclosure and operator heads are moulded from plastic, reducing weight and eliminating conductive surfaces. Mounting hardware for the NPT hub is supplied for direct wall installation. Legend plates marked Start and Stop are integrated on the black and red buttons. The station is restricted from sale in California due to Proposition 65 chemical content.

Highlights

  • 25 mm push buttons fit standard industrial panels
  • Start/Stop legend gives clear machine control
  • 10 A AC / 5 A DC contacts handle motor loads
  • IP40 enclosure resists dust in workshop environments
  • Wall mount with 1/2–3/4 in NPT hub simplifies installation

Specifications

Engine BrandDAYTON
Engine Size25 mm

Questions about this item

How do I mount the 25 mm start/stop control station on a wall, and what wiring step is often missed?

Mount the plastic enclosure to a wall using the 1/2 in to 3/4 in NPT hub; the step often missed is tightening the gland to keep the IP40 seal intact.

Which parts of the 25 mm push-button station will need replacement after extended use?

The maintained push-button operators and the 1NO/1NC contacts rated 10A at 600V AC or 5A at 24V DC are the components that wear first.

What is the first limit reached when the start/stop station runs continuously at full load?

The 10A at 600V AC contact rating is the limiting factor; sustained current above that will overheat the contacts before the IP40 enclosure becomes an issue.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.