We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Bright uncoated 1/8 inch HSS square end mill with four flutes

Cleveland Golf

Cleveland Golf End Mill HSS 1/8 4 FL SGL Sq End CC

SKU CH-XBTW-6T30E

A high-speed steel square end mill with four flutes, 30-degree helix and bright finish for finishing operations

  • TypeHole, Drill, Bore & Wire Gauges
  • General-purpose finishing with four-flute HSS construction
  • 30-degree helix angle promotes smooth chip evacuation
  • Bright uncoated finish suits non-ferrous materials
  • 1/8-inch diameter for precise detail work
  • 3/8-inch shank fits standard collets

Cleveland Golf HSS End Mill 1/8 Inch

The Cleveland Golf HSS end mill is a fractional-inch square-end cutter designed for general-purpose finishing work. It suits machinists and tool-room staff who need a reliable high-speed-steel tool for light profiling and slotting in ferrous and non-ferrous materials.

Upgrade From Coated Or Fewer-Flute Cutters

Switching to this four-flute, uncoated tool makes sense when chip evacuation matters more than coating life and when a 30-degree helix gives the finish quality required. The jump is worth it if your current cutter leaves chatter marks or loads up in softer alloys.

For General-Purpose Finishing In Standard Holders

This cutter fits shops running right-hand, centre-cutting passes with a 3/8-inch shank and a 2-5/16-inch overall length. It is not for buyers who need a corner radius, a coated substrate for high-heat alloys, or a different shank diameter to match their existing tool-holders.

Highlights

  • General-purpose finishing with four-flute HSS construction
  • 30-degree helix angle promotes smooth chip evacuation
  • Bright uncoated finish suits non-ferrous materials
  • 1/8-inch diameter for precise detail work
  • 3/8-inch shank fits standard collets

Specifications

BrandCleveland
TypeHole, Drill, Bore & Wire Gauges

Questions about this item

What shank diameter does the 1/8-inch end mill need for the tool holder?

The shank diameter is 3/8 inch, so the holder must accept that size.

How do you install the end mill without damaging the flutes?

Insert the 3/8-inch shank fully into the collet, tighten evenly, and avoid side pressure on the 30-degree helix cutting edges.

When should the bright-finish high-speed-steel cutter be replaced?

Replace it when the 0.000-inch corner radius shows wear or the four flutes no longer produce a clean finishing cut.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.