We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Cobalt end mill, bright finish, double square ends, 4 flutes, 7/32 inch diameter

Cleveland Golf

Cleveland Golf Cobalt End Mill 7/32 4FL Double Square End CC

SKU CH-2206-PGBMC

A 7/32-inch cobalt end mill with four flutes, double square ends and a 9/16-inch cut length for finishing operations

  • TypeHole, Drill, Bore & Wire Gauges
  • Cobalt construction resists wear during finishing cuts
  • Four-flute design produces smooth surface finishes
  • Double-ended geometry provides two cutting edges per tool
  • 30-degree helix angle supports stable chip evacuation
  • Bright uncoated finish suits general-purpose milling

Cleveland Cobalt End Mill 7/32

The Cleveland Cobalt End Mill is a double-ended square cutting tool built for general-purpose finishing tasks. It suits machinists and maintenance teams who need a reliable fractional-inch cutter for light production or repair work. The bright uncoated surface and 30-degree helix support smooth chip evacuation in a range of common materials.

Upgrade from single-end or coated cutters

This double-ended design effectively provides two cutting ends in one tool body, reducing the frequency of tool changes during finishing passes. The switch is worthwhile when operations run consistent right-hand cuts at 7/32 inch diameter and uncoated cobalt offers sufficient wear resistance. Buyers who need extended tool life in abrasive alloys or high-heat applications will find the bright finish limiting.

Straightforward collet or holder mounting

The 3/8 inch shank fits standard holders, allowing quick setup on manual or CNC milling machines. The 9/16 inch length of cut and zero corner radius demand precise depth control to avoid deflection on the slender 7/32 diameter. Overhang errors or excessive feed rates are the most common causes of premature edge wear or breakage.

Highlights

  • Cobalt construction resists wear during finishing cuts
  • Four-flute design produces smooth surface finishes
  • Double-ended geometry provides two cutting edges per tool
  • 30-degree helix angle supports stable chip evacuation
  • Bright uncoated finish suits general-purpose milling

Specifications

BrandCleveland
TypeHole, Drill, Bore & Wire Gauges

Questions about this item

What shank diameter does the 7/32 inch end mill need for the tool holder?

The shank diameter is 3/8 inch, so the holder must accept a 3/8 inch shank for a secure fit.

How do I install this double-ended cobalt end mill without damaging the cutting edges?

Clamp only on the 3/8 inch shank using a collet or end-mill holder; never tighten on the flutes or the 9/16 inch length of cut.

When should I replace this 4-flute finishing end mill?

Replace it when the bright uncoated corners show visible wear or when the 30 degree helix no longer produces a clean finish on the workpiece.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.