We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Cobalt end mill, bright finish, two flutes, square end, single-ended, 3/8 inch shank

Cleveland Golf

Cleveland Golf Cobalt End Mill 3/8 2FL Single End CC

SKU CH-43NM-HSRWT

Two-flute cobalt end mill with 3/8 inch diameter, 9/16 inch cut length, and 30-degree helix for finishing

  • TypeHole, Drill, Bore & Wire Gauges
  • Cobalt construction resists wear during finishing cuts
  • Two-flute design clears chips efficiently in slots
  • 30-degree helix angle reduces chatter on steel
  • Bright uncoated surface suits general-purpose milling
  • 3/8-inch shank matches standard tool holders

Cobalt End Mill 3/8 Inch Two Flute

This Cleveland Golf cobalt end mill is a fractional-inch square-end cutter built for general-purpose finishing. It measures 3/8 inch in both cutting diameter and shank diameter with a 9/16 inch length of cut and 2-1/2 inch overall length. The tool features two right-hand flutes at a 30 degree helix angle and a bright uncoated finish.

Machinists Finishing Slots And Profiles

The two-flute geometry suits machinists who need good chip clearance in slots, pockets and profile cuts on ferrous and non-ferrous materials. Cobalt substrate handles higher temperatures than high-speed steel for longer edge life. Shops requiring high metal-removal rates or heavy roughing passes should consider tools with more flutes or a roughing profile.

Bright Uncoated Surface For General Use

The bright uncoated finish keeps cost low and works across a wide range of materials without the friction characteristics of coated alternatives. Coated versions of this geometry exist for abrasive alloys or very high-speed runs where heat buildup shortens tool life.

Highlights

  • Cobalt construction resists wear during finishing cuts
  • Two-flute design clears chips efficiently in slots
  • 30-degree helix angle reduces chatter on steel
  • Bright uncoated surface suits general-purpose milling
  • 3/8-inch shank matches standard tool holders

Specifications

BrandCleveland
TypeHole, Drill, Bore & Wire Gauges

Questions about this item

How is the 3/8-inch shank end mill installed in a collet or holder, and what step is often missed?

Insert the 3/8-inch shank fully into a matching collet or holder, then tighten evenly; the step often missed is verifying the tool runs true at the 9/16-inch length of cut before cutting.

What maintenance or replacement will the cobalt end mill need during its service life?

The bright uncoated cobalt flutes will dull with use; plan to resharpen or replace the tool once the 30-degree helix cutting edges no longer produce a clean finish on the workpiece.

What limit appears first when the end mill is run continuously in finishing passes?

Heat buildup at the 3/8-inch diameter cutting zone typically becomes the limiting factor before tool deflection, especially with the uncoated bright finish on cobalt material.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.